CELLO 502524064 Circle 75cm LED IP44 Light Mirror Instruction Manual
- October 30, 2023
- Cello
Table of Contents
502524064 Circle 75cm LED IP44 Light Mirror
Instruction Manual
ASSEMBLY INSTRUCTIONS FOR BATHROOM FURNITURE
- The electrical connections must only be carried out by specialized personnel and functioning must be according to the manufacturer’s instructions.
- Do not use any damaged or broken light fittings.
- Always keep connections and wires away from hot areas.
- The flexible outer cable or cord of this luminaire cannot be replaced; if it is damaged the whole light has to be destroyed.
- The luminaire should not be installed in any position other than the one shown in the assembly instructions nor outside the protection vol. 0-1 (See Figure1).
- The light fitting cannot be modified or forced under any circumstances, as any modification could jeopardise safety and make this dangerous.
- The light source of this luminaire is not replaceable. When the light source reaches the end of its life the full light fitting must be replaced.
- The light sources used in this product are LED lightemitting-diodes, which are not replaceable.
- Do not submerge in water.
- Our products are subject to technical changesand optimizations without prior notice.
USER INFORMATION
Technical data : see fixture label
- Important! Before commencing installation work disconnect the mains cable from the power supply – remove fuse or turn switch to “OFF”! The power supply connection must be done with the suitable connecting box.
- Keep these instructions.
- The luminaire must be installed outside protection area 0-1 (see figure 1).
- This luminaire is only suitable for use in living areas (not for areas constantly subject to moisture and may be used only in accordance with its particular design (e. g. wall luminaires must be firmly installed). 50/60 Hz. COS F=1.
- Do not attach luminaires to surfaces which are damp, freshly painted, or otherwise electrically conductive.
- Use support systems that are in accordance to the weight of the luminaire.
- Keep the wires and connections separated from any heat source.
- Cleaning is limited to the outer surfaces, shades or protective glass, reflectors and covers. It is important to ensure that no moisture enters the terminal compartment or reaches any live parts!
- Do not cover the luminaires with insulating material.
- Do not use luminaries with frayed or cracked glass, until it is replaced
- Not hang or supporting elements on the luminaires.
Class I: The safety of these luminaires is based on their grounding.
Class II: These luminaires have double insulation of all their electrical or wiring parts.
WARRANTY TERMS AND CONDITIONS
The warranty covers defects due to design, raw material and manufacturing
defects occurring within five (5) year of the delivery / purchase date. Defects
found during the warranty period are dealt with in compliance with the
principles defined in the Consumer Protection Act. Rectification of a defect
primarily involves replacing the product or part thereof with a similar or
equivalent product. The warranty does not cover any defect or damage caused by
incorrect installation, neglect of use or care instructions, or incorrect or
negligent handling of the item. The warranty does not cover damage caused by
normal wear and tear, such as scratches and marks, damage caused by impact or
an accident, or transport damage after delivery of the item. For all product
complaints, please contact your dealer before taking any action. Defects
should be reported within a reasonable time of detection (two months) or the
moment they ought to have been detected. The Consumer Protection Act applies
to warranty and product liability.
Electronic devices are recyclable waste. At the end of its useful life,
discard the product in accordance with the applicable regulations.
PROTECTION VOLUMES
Area dimensions may diªer according to current legislation in each country. Electrical appliances must only be connected by competent persons. The luminaire must be installed outside protection area 0-1. A junction box with proper IP rating must be used in the installation. The package contains an IP44 rated junction box.
Assembly
Manufactured for FI- 00580 Helsinki © Kesko 2023.
Made in Spain.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>