IKEA AA-2258808-2 LUNDSKÄR Bath Faucet with Strainer Instruction Manual
- October 30, 2023
- Ikea
Table of Contents
IKEA AA-2258808-2 LUNDSKÄR Bath Faucet with Strainer
Product Information
The product is a mixer tap that must be installed in compliance with local construction and plumbing regulations. The product comes with pre-fitted low or high-pressure hoses/pipes and washers. The mixer tap has a maximum diameter of 55mm and comes with an aerator/flow guide which should be unscrewed with a coin before use.
Technical Specifications
- Water Pressure: 0.2 – 5 bar (2.9 – 72.5 psi) or 0.1 – 10 bar (1.5 – 145 psi)
- Connection Type: G 1/2
Product Usage Instructions
- Ensure that the installation is compliant with local construction and plumbing regulations. If in doubt, seek professional assistance.
- Before changing the mixer tap, switch off the main shut-off valve.
- Unscrew the aerator/flow guide with a coin and allow the water to run freely for a few minutes before screwing it back in place up to the stop. Do not over tighten.
- Check the installation at regular intervals to ensure that it is not leaking.
- Do not tighten the mixer tap too hard as this can damage hoses/pipes and washers.
Note: The product comes with pre-fitted low or high-pressure hoses/pipes and washers. Make sure to select the appropriate option before installation.
Installation must be performed in compliance with current local construction and plumbing regulations. If in doubt, contact a professional.
Switch off main shut-off valve before changing mixer tap.
Instruction
Dimension
Tools
Assembly Instruction
IMPORTANT! Do not tighten too hard: this can damage hoses/pipes and washers.
Before use: Unscrew the Aerator/Flow Guide with a coin and allow the water to run freely for a few minutes. Then screw the Aerator/Flow Guide back in place up to the stop DO NOT OVER TIGHTEN.
Check at regular intervals to make sure that the installation is not leaking.
To comply with UK water regulations, this product shall be installed in
accordance with the following:
Inlet supply hoses shall be installed where light is excluded.
Water supplies shall be at reasonably balanced pressures from a common source
(e.g. hot and cold supplies both from the same storage or both from a supply
pipe). Where the fitting is supplied from unbalanced supplies (e.g. hot and
cold supplies from separate sources) an
‘Approved’ single check valve or some other no less effective backflow
prevention device shall be fitted immediately upstream of both hot and cold
water inlets.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>