weber SmokeFire EPX4 Wood Fired Pellet Grill User Guide
- October 30, 2023
- Weber
Table of Contents
weber SmokeFire EPX4 Wood Fired Pellet Grill
Product Information
Weber STEALTH Edition EPX4 and EPX6
The Weber STEALTH Edition EPX4 and EPX6 are grills designed for outdoor cooking. The grill comes with an assembly guide, and it is recommended that two people assemble the grill. The assembly should be done on a flat, level, and soft surface. The use of power tools for assembly is not recommended. It is important to keep the lid closed while assembling or moving the grill unless otherwise instructed. All parts must be assembled, and all hardware must be tightened before operating the grill. The protective film and packaging materials should be removed before using the grill.
It is recommended not to remove the protective end pad until after the legs are assembled. It is also advised not to remove the grill from the cardboard base or the blue tape on the lid until instructed. The grill is compatible with Weber Crafted accessories, which are sold separately.
Product Usage Instructions
- Place box E underneath the hopper for stability.
- Match stickers for proper leg installation.
- Fully tighten all screws.
- Ensure that the tip of the glow plug is through the opening in the pellet grate.
- Make sure all wire connections are secure before reinstalling rear access panel.
Product Tools Required
- No power tools are required for assembly.
- The tools included are: 1 (one) wrench, 2 (two) screwdrivers, and 3 (three) hex keys.
Note: The instructions are available in multiple languages, including enUS, esMX, and frCA. For more information, visit www.weber.com.
Warnings
- Two people required for assembly.
- Before unpacking your grill, follow assembly guide for specific unpacking and assembly instructions.
- Assemble grill on a flat, level, and soft surface.
- Do not use power tools for assembly.
- Always keep the lid closed while assembling or moving the grill unless otherwise instructed.
- Make sure all parts are assembled and all hardware is tightened before operating your grill.
- Remove all packaging materials and protective film before operating your grill.
Unboxing
Warning
- Do not remove protective end pad until after the legs are assembled.
- Do not remove grill from cardboard base.
- Do not remove the blue tape on lid until instructed.
Parts
- For use with Weber Crafted accessories only. Accessories sold separately.
TOOLS INCLUDED
TOOLS REQUIRED
- Download the free BILT app for 3D step-by-step instructions.
Precautions
Installation Instructions
Warning: Place box “E” underneath the hopper for stability.
Warning: Match stickers for proper leg installation.
Warning: Install top screw only halfway into leg.
Warning: Install top screw only halfway into the leg.
-
Fully tighten.
-
Fully tighten.
-
ON
-
Tighten hardware until it is secure.
-
Warning: DO NOT OVERTIGHTEN HARDWARE.
Warning: Remove ash and grease drawer before installing housing.
Warning: Remove blue tape from lid.
- Ensure the tip of the glow plug is through the opening in the pellet grate.
Warning: Make sure all wire connections are secure before reinstalling rear access panel.
-
EPX4
-
EPX6
REGISTER TODAY
- Register your barbecue to receive exclusive WEBER content that is sure to make you the ultimate backyard hero.
WEBER-STEPHEN PRODUCTS LLC
© 2022 Designed and engineered by Weber-Stephen Products LLC,
1415 S. Roselle Road, Palatine, Illinois 60067 USA.