NCF 315543 Pisces King Platform Bed Instruction Manual
- October 30, 2023
- NCF
Table of Contents
315524 Leo Queen Platform Bed
Instruction Manual
ASSEMBLY INSTRUCTIONS
B1563-300 GEMINI 5/0 Q PANEL BED-HB/FB/RAILS
Thank you for purchasing this quality product. Be sure to check all packing
materials carefully for small parts, which may have come loose inside the
carton during shipment. Identify and count all items and compare with the
parts list and/or hardware list shown.
PARTS LIST
| No | ITEM | Qty |
|---|---|---|
| A | Headboard | 1 pc |
| B | Footboard | 1 pc |
| C | Headboard Leg LSF | 1 pc |
| D | Headboard Leg RSF | 1 pc |
| E | Bed Roll-Out Slats | 2 sets |
| F | Bed Slats Support | 8 pcs |
| G | Side Rail Left | 2 pcs |
| H | Side Rail Right | 2 pcs |
| I | Center Slat | 2 pcs |
| J | Side Rail Leg | 2 pcs |
HARDWARE LIST
| No | ITEM | Qty |
|---|---|---|
| 1 | JCBC M6 x 30mm | 12 pcs |
| 2 | JCBC M6 x 50mm | 8 pcs |
| 3 | Flat Washer 1/4″ID x 19mmOD Blk | 12 pcs |
| 4 | ALLEN KEY m4x65mm Blk (FOR HB LEG) | 1 pc |
| 5 | ALLEN KEY m5x65mm Blk (FOR SIDE RAIL) | 1 pc |
| 6 | Flat Head Chipboard Screw m4x32mm Rbw | 32 pcs |
STEP 1.1 :
Attach Head Board Leg ( C,D ) to Head Board ( A ) as shown using JCBC BOLT( 1
) with Flat washer (3)and securing with ALLEN KEY ( 4 ) .
STEP 1.2 : Fix the other holes with Csk Screw (6) as shown.
STEP 2.1 :
Attach Side Rail ( G ) & ( H ) to the Side Rail Leg ( J ) as shown using JCBC
BOLT( 1 )with Flat washer (3)and securing with ALLEN KEY ( 4 ) by outside side
rail (G) & (H) .
STEP 2.2 :
Loosen JCBB Bolt at Headboard & Footboard Leg using Allen Key (5) (Do not
tighten them before Hook SET-UPSIDE RAIL TO HEAD BOARD (A) closely and push
down to fit and tighten them accordingly.
Repeat step 2.2 with other end of rail to hook onto FOOTBOARD (B).
STEP 3 : Fix the Bed Slat Support (F ), to Bed Slat (E) and Center slats
(I) tighten with JCBC Bolt (2) as shown . Install the bed slat ( E ) to side
rail ( G ) & ( H ) and tighten with Csk Screw ( 6 ) as per diagram shown.
(NOTE: THE SETUP MUST DONE AT THE DECIDED LOCATION FOR THE BED TO OBTAIN
PERFECT STABILITY) Repeat step 3 for other set of slats assembly.
NOTE : MUST TIGHTEN SCREWS PERIODCALLY WITH USE SCREW WILL BECOME LOOSE CHECK TIGHTNESS OF ALL SCREW EVERY 6-8 WEEKS.