ENDON 97663 3lt Semi Flush Instruction Manual

: June 4, 2024
: ENDON

Table of Contents

Safety Warnings
Care Information
Assembly/ User Instructions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

97663 3lt Semi Flush
Instruction Manual

ENDON 97663 3lt Semi Flush

Ceiling Fitting
INSTRUCTION MANUAL

Safety Warnings

This product is only suitable for connection to a 220-240V-50Hz supply in accordance with current IEE wiring regulations and should be installed in accordance with local building regulations. It is for indoor use only and is not suitable for a bathroom location.
Before installing your light fitting always switch off the mains supply, remove the appropriate fuse or switch off the appropriate circuit breaker before commencing installation. Ensure that no one else has access that would enable the supply to be inadvertently reconnected.
This Is a Class I product and must be Earthed. The terminal blocks are supplied according to the requirements of the fitting.
Never fit bulbs of a higher wattage than those specified on the label (as these may cause overheating and damage the fitting)
If you are in any doubt about your competence please consult a qualified electrician.
If any modification is made it will invalidate the warranty and may render the product unsafe.

Care Information

Allow 10 minutes to cool before replacing. adjusting or cleaning. Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

Assembly/ User Instructions

Before you start
Please read these instructions carefully before fitting and retain for reference. Check the packaging and make sure that you have all the required parts. Follow each assembly step in order to prevent Incorrect assembly. Please note – This instruction covers multiple fining styles. While the assembly steps are the same, your product may vary from the diagram.
The Light pack contains:
Light fitting
Fixing pack
The following tools may be required:
Selection of the cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.

Decide on the position of the light fitting, or remove the existing light fitting. Take note of the position of the electrical connections. Ensure there is a solid mounting surface, preferably a wooden joist or joist bridge to support the weight of the light fitting.
Remove the fixing bracket (A) from the ceiling cover and attach to the ceiling using the screws provided. Ensure there is a joist at the point of fixing to support the weight of the product. Take care to avoid damaging any concealed wiring and pipes.
Support your fitting and connect the house wiring to the terminal block – see expanded wiring details below. There may be more than one set of cables in the “loop° connections. If there is a “Ring Circuit” and you do not understand the connections you must consult an electrician. Any loose tramline! blocks – not secured to ceiling cup
– should always be covered with 2 layers of good quality insulation tape.
This product has “L” shaped fixing holes to allow easy fixing to the ceiling strap. Locate these slots around the small screws (B) on the ceiling strap (A). Rotate the ceiling cover to attach the product to the strap. Tighten the screws to secure them. Take care not to trap any wiring.
Fit the bulbs (C).
NOTE: Never fit bulbs of a higher wattage than those specified on the label (as these may cause overheating and damage the fitting)
Turn on the power and test.