Stone garden lifestyle 699-0836S Garden Furniture Set User Guide
- October 30, 2023
- Stone garden lifestyle
Table of Contents
Care and User Guide
For your new garden furniture set
IMPORTANT: PLEASE REGISTER YOUR STONE GARDEN LIFESTYLE PRODUCT BEFORE
ASSEMBLY
Using the unique serial number found on the cover of this document, please
visit https://bit.ly/StoneGardenWarranty to register your product.
Affix Serial Number HERE
Doc Ref: 699-0836S_Rev.B
Care Guide for your new garden furniture set
Thank you for purchasing your new Stone garden lifestyle furniture set. Our
products come with a 25 year warranty on all aluminium parts, fabric and
mechanical parts come with a 1 year warranty. To help look after and even
increase your garden furniture’s longevity, we have listed some tips below on
how to look after it.
-
Regularly wipe down the metal frames with warm soapy water and a sponge to clean.
Avoid using heavy detergents or power washers. -
Perform Maintenance at least once a year in order to extend the life of your furniture.
Check all fixings are secure. -
The fabric is fire retardant and easy to clean, however for more stubborn stains, use a soft brush and a fabric cleaner to help remove any marks.
-
Use a cover when your set is not in use to avoid damage to tempered glass or metal surfaces under extreme weather conditions.
-
Using a parasol in hot weather will help to avoid damage to tables and sofa surfaces.
-
Try no to place glasses on table tops without coasters, this will help to avoid the magnifying effect from the glass, which could discolour or damage the surface.
Important Information
When unpacking, a Stanley knife or scissors may damage your new garden
furniture set, so ensure unpackaging your new set with care. Any accidental
damage is not covered by your warranty. It’s the customer’s responsibility to
dispose of all packaging.
We recommend never to leave your parasol up when not in use, no matter
the weather. This can cause parts to break and become unusable, using our
parasol cover can prevent damage caused by weather conditions. Failing to do
this, will invalidate your warranty.
We recommend you use covers to protect your outdoor furniture when not
in use. Covers must be removed periodically to minimise moisture build up.
Be careful when removing covers off your garden furniture. Whilst
durable, garden furniture covers can rip when removed with excessive force
over corners of tables and chairs.
Footstool Set with Two Chairs and Side Table
Product Code: 0258-G-2C-2F-ST
Important Information
** Please read these instructions carefully. Note the safe operational
requirements, warnings & cautions. Use the product correctly and with care for
the purpose for which it is intended. Failure to do so may cause damage and/or
personal injury and will invalidate the warranty. Please keep these document
safe for future use.
About the Product**
Made from Aluminium with a powder coated finish, to protect from corrosion.
Available in both anthracite grey and porcelain white .
Supplied with thick, padded, grey cushion.
Safety Instructions
**** Cautions and instructions in this manual cannot cover all possible
situations and conditions that may occur. Common sense and caution are factors
which cannot be built into these products.
Responsibility as a customer;
- Ensure the items are assembled properly and securely.
- Avoid tipping, place on firm flat ground floor.
- Do not stand or jump on furniture.
Assembly
Note: Wear correct safety gloves, It is inherent with fabricated metal
parts, edges and corners can cause minor cuts if improperly handled during
assembly.
TWO PERSON ASSEMBLY
Most procedures will not require two people but it may be easier to have
assistance.
PERSONAL PROTECTION EQUIPMENT
We advise appropriate personal protective equipment is worn during assembly.
Individual Products
Corner Sofa
Product Code: 0258-CS
Made from aluminium with a powder coated finish.
Topped with a luxuriously comfortable UV and water-resistant grey seat
cushions.
- Size: L 230 x W 230 x H 84 cm
- Assembly: Nuts & Bolts Qty: 4, cushions Qty: 9.
Locate and secure 2x M8 bolts to 2 x M8 nyloc nuts using M8 washers as shown
above.
Tools needed 13mm socket or spanner will be required.
Sofa
Product Code: 0258-1S
Made from aluminium with a powder coated finish.
Topped with a luxuriously comfortable UV and water-resistant grey seat
cushions.
- Size: L 153 x W 82 x H 84
- Assembly: Cushions Qty: 3.
Chair
Product Code: 0258-1C
Made from aluminium with a powder coated finish.
Topped with a luxuriously comfortable UV and water-resistant grey seat
cushions.
- Size: L 82 x W 73 x H 84
- Assembly: Cushions Qty: 2.
Lounger
Product Code: 0258-1R
Made from aluminium with a powder coated finish.
Topped with a luxuriously comfortable UV and water-resistant grey seat
cushions.
- Size: L 203 x W 78 x H 101
- Assembly: Cushion Qty: 1, with straps.
Footstool
Product Code: 0258-1F
Made from aluminium with a powder coated finish.
Topped with a luxuriously comfortable UV and water-resistant grey seat
cushion.
- Size: L 60 x W 60 x H 45
- Assembly: Cushion Qty: 1, with straps.
Side Table
Product Code: 0258-ST
Made from aluminium with a powder coated finish.
- Size: L 40 x W 40 x H 43
- Assembly: N/A.
Fire Pit Table
Product Code: 0258-FT
Made from aluminium with a powder coated finish.
Gas powered, protective glass surround for added safety.
- Size: L 127 x W 127 x H 67
- Assembly: Refer to Fire pit user manual..
Dual Height Square Table
Product Code: 0258-DT
Made from aluminium with a powder coated finish.
Dual height table.
- Size: L 127 x W 127 x H 67
- Assembly: M6 x 35mm pan head torx bolts. Qty: 4.
Locate and secure 4x Torx M6 x 35mm flanged bolts.
As shown above.
Tool required: M6 Torx screw driver.
- Locate and lift inside table arms into the locked position as shown above.
- Locate and secure M6 x 35mm pan head torx bolts to table top as shown above.
Operation Procedure to Change Table Height
Fig.1 – Table in coffee table position.
This procedure will require two people.
To lower to minimum height (coffee table position). Fig. 1
- Place a foot in both table recesses at adjacent sides. Fig. 3 (these will help steady the table base, when lifting).
- Lift slightly upwards to unlock table top.
- Lower gently in a downwards direction, until the table top stops.
To lift table to maximum height (dinning height position). Fig. 2
- Place a foot in both table recesses at adjacent sides. Fig.3 (these will help steady the table base, when lifting).
- Lift table to maximum height, lift in an upwards direction until table locks outs.
Customer Service: +44 (0) 1889 272 056
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>