KAFULLE 3 in 1 Foldable Magnetic Wireless Charger User Manual
- October 30, 2023
- KAFULLE
Table of Contents
3in1 Wireless Charger
User Manual
Device Layout:
Product Parameter
Product name: 3 in 1 wireless charger
Material quality: ABS + Silicone
Dimensions: 247+74.57.5MM
Interface: USB-C
Input: 9V-2A,12V-2A
Mobile phone output: 5W/7.5W/10W/15W.
iWatch output: 25W
Airpods: 3W
Compatibility: support mobile phones, Airpods, and iWatch that comply with the
Qi standard
Steps for usage
‘The device is connected to the power supply through the charging cable, and
then it can be powered on. When charging the mobile phone, place the mobile
phone flat in the mobile phone charging area to start charging the mobile
phone. After fully charged, simply take off the phone, during the charging
process, if you need to terminate the charging, take it directly. When
charging the Apple Watch, place the iWatch flat in the charging area to start
charging the watch. After fully charged, directly remove the iWatch; During
the charging process, if you need to terminate the charging, remove the Watch
directly. When charging the Airpods , place the Airpods flat in the charging
area to start charging ;
After fully charged, simply remove the Airpods; During the
charging process, if you need to terminate the charging, remove it directly.
Special Note:
– When charging the iwatch, recommended to use flat and vertical charging at
90 degrees. Do not select 30 degrees, as charging may not be possible at this
angle.
2Recommended to use the supplied charging cable for power supply, and not to
use the original iphone cable.
Packaging accessories
3in 1 wireless charging 1 USB-C charging cable 1 Mannual 1
Packing box *1
The content of this manual and product specifications are subject o change
without notice:
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’’s RF Exposure guidelines, This equipment
should be installed and operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>