myCharge Power+Case CPL28K CPL28M CPL28W User Manual

: October 30, 2023
: myCharge

Table of Contents

myCharge Power+Case CPL28K CPL28M CPL28W
IN THIS PACKAGE:
RECHARGING POWER+CASE
LED INDICATORS
CHARGING iPHONE 6/6s
WARRANTY INFORMATION:
FCC COMPLIANCE:
DOWNLOAD
Read User Manual Online (PDF format)
Download This Manual (PDF format)

myCharge Power+Case CPL28K CPL28M CPL28W

QUICK START GUIDE

Thank you for choosing myCharge POWER+CASE

REGISTER your product at myCharge.com You will be entered to win one of our amazing gifts!

IN THIS PACKAGE:

POWER+CASE
Recharging cable
Quickstart guide

RECHARGING POWER+CASE

Connect the included recharging cable to any USB power source. Fully charged unit shows 4 solid, non-blinking LEDs.

3 ways to recharge: Wall outlet, car, computer

Once PowerCase is fully charged and disconnected from a power source, your PowerCase will remain on and pass power through to your iPhone until the case is turned off or runs out of power.

To conserve the battery of your PowerCase, press and hold the power button for 2 seconds to turn it off until a charge is needed.

LED INDICATORS

Press power button to see battery level

LED INDICATORS

CHARGING iPHONE 6/6s

Press ﬁt iPhone 6/6s into case, bottom ﬁrst.
Charging should begin automatically –
if it doesn’t, press the power button.

Charge and Sync:

To easily sync your phone, use the included recharging cable to connect your Power+Case to your computer.

Removing iPhone from Power+Case:

Push iPhone out through the camera hole to remove it from the Power+Case.

WARRANTY INFORMATION:

At myCharge, we’re dedicated to making the highest quality products possible. In that, we provide a one-year limited warranty from the date of purchase. Keep a copy of your receipt as proof of purchase and register your product at mycharge.com and check for the latest product updates as they develop. Failure to register your product and/or to provide proof of purchase may void the warranty.

Warranty Instructions and Information visit: mycharge.com/warranty and select your model.

MYCHARGE SUPPORT: support.mycharge.com

WARNING: Read all instructions and warnings prior to using this product. Improper use of this product may result in product damage, excess heat, toxic fumes, fire or explosion, for which myCharge is not responsible.

Do not expose battery to heat sources, extended direct sunlight or other high-temperature environments.
Avoid drops and excessive impacts to the battery.
Do not disassemble, attempt to repair or replace any part of the housing or battery.
Do not attempt to charge the battery using any other method, apparatus, or connections other than the device’s charging cable.
Never dispose of batteries in the garbage. This is unlawful under state and federal environmental laws and regulations. Always take used batteries to your local battery-recycling center.
WARNING: This product contains chemicals known to the state of California to cause cancer, birth defects and other reproductive harm.

FCC COMPLIANCE:

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Note: Changes or modifications not expressly approved by myCharge could void the user’s authority to operate this equipment.

“Made for iPhone” means that an electronic accessory has been designed to connect specifically to iPhone and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPhone may affect wireless performance.

CPL28K-A; CPL28M-A; CPL28W-A