GAGAKING XDL-WPB05 Portable Watch Charger User Manual
- October 30, 2023
- GAGAKING
Table of Contents
GAGAKING XDL-WPB05 Portable Watch Charger
Product Diagram
Product parameters
Name: Portable watch charger
Model: XDL-WPBOS
lnput: SVIA
Output: 3W Max
Capacity: 1400mAh/5.18Wh
Size: 74.1249.9216.2mm
Instructions for use
- Charging the portable charger: plug the cable USBA into the wall adapter, connect the other end to this product, the product will prompt the current power, when fully charged, the 4white lights will be light constantly.
- The product charges the watch: put the watch in the corresponding launch area, the watch will automatically adsorb after it is closed to the product, and then tap the side wake button, at which time the product begins to charge the watch.
- When you charge the portable charger, you can also tap the side wake-up button to charge the watch, and the watch will be charged first.
Packing list
- Portable watch charger x 1
- User Manual x l
- Charging cable x 1
Safety guidance
- This product uses lithium-ion batteries, overcharge or over discharge will affect the service life of the product, please charge and disconnect the power supply after charging and fully charging in time.
- The product will generate a certain amount of heat when used, which is a normal phenomenon.
- Do not squeeze, disassemble the battery or put the battery in a high temperature environment (60.C and above) for a long time, otherwise there may be a risk of leakage or explosion.
- If stored for a long time, please keep the electricity of the product at about BO% and store it in a dry and ventilated place.
FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
The device has evaluated to meet general RF exposure requirement. The device
can be used be in portable exposure without restriction.