nevir NVR-7715-16RD2-N 16 Inch 41 cm LED HD Television User Manual
- June 10, 2024
- nevir
Table of Contents
nevir NVR-7715-16RD2-N 16 Inch 41 cm LED HD Television
Installation
-
CD Locate the TV in a room where direct light does not strike the screen. Total darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing.
-
Allow enough space between the receiver and 1the wall to permit ventilation.
-
Avoid excessively warm locations to prevert possible damage to the cabinet or premature component failure.
-
Do not install the TV in a location near heat sources such as radiator, air ducts, direct sunlight, or in a place somewhere like close compartment and close area. Do not cover the ventilation openings when using the TV.
-
The indicator light will last about 30 seconds to go out after cutting off the electricity, during this period, you cannot repower it on until the indicator light goes out, thanks a lot for your attention!
-
Use only switching adapter listed test in the user manual.
Switching Adapter Model:THX-120 l 50KDV
Made by: ShenZhen TIANHANGXING Electronic Technology Co.,Ltd. -
To prevent the spread of fire, keep candles or other open flames away from this product at all times.
WARNING
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
- CAUTION: TO AVOID THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER (OR BACK).
- NO USER-SERVICEABLE PARTS INSIDE.
- REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
- This symbol is intended to alert the user to avoid the risk of electric shock, do not disassemble this equipment by anyone except a qualified service personnel.
- This symbol is intended to alert the user to the presence of important operating and maintenance instructions in the literature accompanying the equipment.
Caution
-
High voltages are used in the operation of this product.
Do not open the product’s casing. Refer servicing to qualified service personnel . -
Do not open the product’s casing. Refer servicing to qualified service personnel .
-
the main unit to rain or moisture, do not place objects filled with liquids, such as vases, on the apparatus.
-
Do not drop or puish objects into the television cabinet slots or openings. Never spill any kind of liquid on the television receiver.
-
Avoid exposing the main unit to direct sunlight and other sources of heat. Do not stand the television receiver
directly on other products which give off heat. E. g. video cassette players, Audio amplifiers. Do not block the ventilation holes in the back cover. Ventilation is essential to prevent failure of electrical component. Do not squash power supply cord under the main unit or other heavy objects.
- Never stand on, lean on, push suddenly the product or its stand. You should Pay special attention to Never stand on, lean on, push suddenly the product or its stand. You should Pay special attention to
- Do not place the main unit on an unstable cart stand, shelf or table. Serious injury to an individual, and damage to the television, may result if it should fall.
- When the product is not used for an extended period of time, it is advisable to disconnect the AC power cord from the AC outlet.
- The LED panel used in this product is made of glass. Therefore, it can break when the product is dropped or applied with impact. Be careful not to be injured by broken glass ]pieces in case the LED panel breaks.
Main unit description
Control Panel Button Function
- SOURCE : Select the input signal.
- MENU : Press to select the main menu.
- VOL+: Volume up.
- VOL-: Volume down.
- CH+: TV channel up.
- CH-: TV channel down.
- POWER: Turn the TV on or off.
TV Terminal Connections
Optional Configuration as below:
Connect the USB to the USB jack on the set.
NOTE
- It is only 500 mA MAX of DC current output when you connect with USB jack
- To ensure the Mobile HD works well, you slb.ould use other power supply for the Mobile HD. And do not use the USB jack in the same time.
Remot control
Menu Operation
Press [MENU] key to show main menu, there are six functions under main menu, they are Channel, Picture, Sound, Time, Setup,Lock, Press [LEFT] / [RIGHT] to select these functions.
Channel
Auto Tuning
Under the Auto Tuning of CHANNEL menu
Press [ENTER] key to enter Auto Tuningthe following prompt box will appear:
Program Edit
Channel edlit function includes -Delete/Move/Skip/Fav/Back. Fav/Skip mark will
appear only after the users have some setting on 1the channel(Fav and Ship
can’t be set together).
- Delete : Press [RED] key to cancel the program that the cursor 1s 1n.
- Move : Press [YELLOW] key, according to the prompt, execute MOVE function, move the program order
- Skip : Press [BLUE] key, the program the cursor is will be marked with SKIP. When execute CH+/CH-, skip this program,. and this program can’t be selected even press the number key.
- Favorite : Press [FA V] key, mark the program the cursor is in as favorite program.
- Back : Press (Back) key to return to the previous menu.
Picture
Sound
Time
- Clock: It shows current time information. It is under Hide status and can’t be selected. When there is no searching, after power on, it shows time beginning from 00: 00; after DTV searching, it shows current code’s time information under JDTV.
- Time Zone: It is set default according to shipping area and clients requirements; when Auto Tuning searching, it will auto switch according to current selected country.
Lock
- Channel Lock: You need to input a password to enter submenu, the password default is 0000.
- Set Password: Set system password.
- Chaimel Lock: Press green (LOCK) , then there is LOCK icon on this selected channel, and the channel is locked. Parental Guidance: Set parental guidance.
Setup
OSD Language: Select the language and default language according to shipping area and clients requirements.
EPG
Press [EPG] hotkey to display the EPG menu, only effect under the DTV.
PVR
Record
In DTV, press [REC] button, it will display the following menu below, and
start to burn the current DTV program. Press [LEFT]/[RIGHT] button to move
cursor to exercise different function according to hint.
Playback
After burning the program, exit from Record, press [PLAY] button to implement
Playback function. Different function can be implemented according to hint.
Time shift
In DTV, press [PLAY/PAUSE] button to implement the function of Timeshift.
Press [LEFT]/[RIGHT] button to move cursor to exercise different function
according to hint.
Media Player
In the option of Media Player on MainMenu, Press [ENTER] to enter the Media
Player menu, see the picture as follows:
Press [LEFT]/[RIGHT] to select Movie, Music or Photo.
Take Movie function for example, when there i:s focus point on Movie function, press [ENTER] button to enter into File Selector menu.
On FileSelector menu, select film source that needs to be play according to
the hint. Press [PLAY/PAUSE] button to enter into the play mode of full
screen; press
[PLAY/PAUSE] to return to Media Player menu.
Movie
Media Player menu, move cursor to moive, press [ENTER] button to enter into
FileSelector menu. Select the file you want to play, press [PLAY/PAUSE] to
enter into full screen play.
Press [LEFT]/[RIGHT] button to move cursor, and oper ate according to
different hint.
Music
In the same way, on Media Player menu, move cursor to Music, press [ENTER]
button to enter into the FileSelector menu. Select the file you want to play,
press [PLAY/PAUSE] to enter into full screen play. Press [LEFT]/[RIGHT] button
to move cursor, and operate according to different hint.
Photo
In the same way, on Media Player menu, move cursor to Photo, press [ENTER]
button to enter into FileSelector menu. Select the file you want to play,
press [PLAY/PAUSE] to enter into full screen play. Press [LEFT]/[RIGHT] button
to move cursor, and operate according to different hint.
Trouble Shooting
Before consulting service personnel, check the fol.lowing chart for possible solutions.
| PROBLEM | SOLUTION |
|---|
TV will not tum on
| • Make sure the power cord is plugged in.
• The batteries in the remote control may be Exhausted; replace the batteries.
No picture, no sound
| • Check the cable between TV and antenna/ external AV device.
• Press the power button on the remote.
• Press the SOURCE button the remote, then press the
” A. I T “button repeatedly to select the TV source.
Poor picture, sound OK
| • Checkthe cable between TV and antenna/ external AV device.
• Try another channel, the station may have broadcast difficulties.
•Adjust the brightness/contrast in the Video menu. Check
that the unit is set to PAL
Audio noise| • Move any infrared equipment away from the TV.
The TFT LED panel uses a panel consisting of sub pixels which requires sophisticated technology to produce. However, there may be a small number of bright or dark pixels on the screen. These pixels will have no impact on the performance of the product.
If at any time in the future you should need to dispose of this product please
note that: Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local Authority
or retailer for recycling advice. (Waste Electrical and Electronic Equipment
Directive)
The European Directive 2002/96 /JE:C on Waste Electrical and Electronic
Equipment (WEEE) required that old household electrical appliances must not be
disposed of in the normal unsorted municipal waste stream. Old appliances must
be collected separately in order to optimize the recovery and recycling of the
material they contain and reduce the impact on human health and the
environment. The crossed-out “wheeled bin” symbol on the product remind you of
your obligations that when yiou dispose of the appliance, it must be
separately collected.
Besides that, waste batteries and/or accumulators must be removed prior to
delivery of WEEE, through the separated collection channels provided for this
purpose (distributors and/or facilities from Local Authorities)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>