SR PORTABLES CLEO Portable Lithium Solar Generator Instruction Manual

Portable Lithium Solar Generator
Instruction Manual

Packing List

1 Pcs Cleo Portable Solar Generator
1 Pcs AC Adaptor (including AC charging cable)
1 Pcs Cigarette Lighter Cable (cigarette port to DC7909 connector male)
1 Pcs MC4 Cable (MC4 connector to DC 7909 connector male)
1 Pcs User Manual
1 Pcs Warranty Card

Please visit our website www.srportables.com to register your product

Part Description

1. Handle Bar
2. LED Light
3. Main Power Button
4. DC Power Button
5. AC Power Button
6. DC12V Car ignitor output port| 7. Type-C PD Output port
8. USB Output Port
9. LCD Screen
10. DC 12V 5521 Output port
11. LED Light Button
12. Charging Port
13. AC Output Port
---|---

Safety and Precautions

Safety Warning

1. Please read all the safety warnings and labels before using the product.
2. Avoid exposing the product to rain or using the product in a humid environment.
3. Do not install the product near heat sources, such as electric furnaces and heaters.
4. Wipe the product clean with a dry cloth.
5. In case of fire, use dry powder fire extinguishers for this product. Do not use water fire extinguisher, which may cause electric shock.
6. Please do not alter or disassemble this product.

Safety and Precautions
Storage and Maintenance

1. Operating and storage environment may influence product life and the reliability of performance. Remember to:
   (i) Place the product in a dry and well- ventilated area with mild temperature (suitable temperature: 0°C -45°C, suitable relative humidity 10% ~ 90% )
   (ii) Place the product in a safe area where it will not fall or shake.
   (iii) Keep the product away from corrosive and combustible material.

2. The product will turn itself off when the battery voltage is very low. If this happens, you need to charge the battery within 2-3 months.

3. If you are not going to use it for a long time, please charge it fully before storage and then charge it at least once every month. Store the product in a dry environment.

How to Charge this Product?

Solar Panel to Charge the Product

1. Choose a suitable solar panel (Recommended SR Portables 100W Foldable Solar Panel)
2. Keep the solar panel under direct sunlight and facing the sun.
3. Connect the solar panel to the product at the AC port( Part 12 in the Part Description) using the MC4 cable. Please charge the product under Operational Temperature:
4. Charge 0°C ~ 45°C, Discharge -20°C ~ 60°C (powering appliances)
5. When the product is fully charged by the sun, it will stop charging automatically.(The charging time is different under different sunlight intensity)
6. All products can be charged and used simultaneously
7. During charging, it is normal for the product to get a little hot.
8. Please make sure the cable connections are secure and stable, or it might result in overheating and short circuits.

AC Charger to Charge the Product

1. Always use the standard AC charger that comes with the product.
2. Insert one end of the adapter into the wall outlet and insert the other end into the input port( Part 12 in the Part Description) of the product.
3. Please unplug the charger after charging is completed. (It takes about 5-6hrs to fully recharge the product if using a 90W AC adapter charger).
4. During charging, it is normal for the product to get a little hot.
5. Make sure that the wiring is connected properly, otherwise the contact terminals may melt or ignite at high temperatures.

Car Charger to Charge the Product

1. Connect the product to the cigarette lighter socket( Part 12 in the Part Description) in the car with the cigarette lighter cable provided in the package.
2. The product will be fully charged with a 24V car battery, but only partially charged with a 12V car battery.
3. Charge the product after starting the car.
4. Make sure that the wiring is connected properly, otherwise the contact terminals may melt or ignite at high temperatures.

Turn ON/OFF the Product

1. Turn on the product: Press and hold the master power button about 2 seconds to turn on the product.
   The LED indicator light and the display screen will light up.

2.  Turn off the product: Press and hold the master power button about 2 seconds to turn off the product.
   The display screen and the LED indicator light would turn off.

AC/DC Output

1. Turn on AC/DC output: Press and hold the AC/DC power button to turn on the product. The corresponding LED indicator light would light up and the display screen would show “AC ON/DC ON”.
2. Turn off AC/DC output: Press and hold the AC/DC power button to turn off the product.
   The LED indicator light would turn off and the display screen would show “AC OFF/ DC OFF”.
   Note: Check to make sure the product is turned on. Otherwise, you cannot turn on the AC/ DC output.

Output

Technical Specifications

Output

| Rated voltage| 100 -120 Vac| I 220 – 240 Vac
AC output| Rated power| 300 W
Peak power| 450W
Overload Capability| 300W5 load < 4sow@i2os: 450W5load@1s:
Frequency| 50/60Hz (adjustable)
DC12V Output (cigarette lighter)| Rated voltage| 12Vdc (1214V workable)
Rated current| 10A 0
DC12V Output (5521)| Rated voltage| 9.6 -12.6Vdc 00
Rated current| 3A
USB output| CC| BC1.2.Apple.Samsung
Rated voltage| 5V
Rated current| 3A
Type C Output| OC| PD2.0 (45W)
Rated output| 5V3A. 9V3A .12V3A .15V3A . 20V2.25A
LED Torch| While the power button is on. press the LED light button repeatedly. The order of LED light will be: full brightness-half brightness- SOS- Off
Solar PV Input 0
Input voltage| 14 – 40 Vdc
Input power| 120W MAX
Battery
Rated capacity| 416Wh
Rated voltage| 11.1 Vdc
Battery cell type| Lithium ion battery. 4000+ cycles to 80%
Voltage range| 9.6 – 12.6Vdc
General
Protection level| IP21
Working environment condition| Relative humidity: 10% – 90%
Temperature: 0°C – 45°C
Size| 300’159’219mm
Net weight| 6.2 kg

Operating Conditions

1. Operational Environment: Indoor and Outdoor (non waterproof)
2. Operational Temperature: Charge 0°C ~ 45°C, Discharge -20°C ~ 60°C (powering appliances)
3. Storage: -20°C ~ 45°C

Troubleshooting

If the product cannot charge or power appliances, please check the following:

1. Make sure the power button is turned on.
2. Make sure the AC and DC power buttons are on, viz. the LED on the right of the button is green.
3. Check the battery capacity – if it’s lower than 10%, please recharge the product as soon as possible.
4. Make sure the load power connected is not exceeding the load limit of this product. Each port has a limit for the connected power load.

If the product still does not work, then please contact our after sale service center.

the temp 70°C
0.00E+00| Low temperature protection| < -8°C| > -2°C.self-recovery
0.00E+00| Battery Over temperature| >68°C| < 58°C.self-recovery
0.00E+00| Battery low temperature| < -8°C| > -2 tself-recovery
0.00E+00| Battery charge over temperature| >48°C| < 38°C.self-recovery
0.00E+00| Battery charge low temperature| < 0°C| >5°C.self-recovery
0.00E+00| Total voltage too low| <9.6V| >10.5°Crecover
charging.
0.00E+00| PV input over voltage| >45V| < 40V self-recovery
0.00E+00| DC 12V output over voltage| Battery voltage >13V| Recover by pressing any button
0.00E+00| DC12V-1output over loaded| Load power >140W
0.00E+00| DC12V-1 output over current| output current >11A or
short-circuit
0.00E+00| DC12V-1 input over current| Current > -1A
0.00E+00| DC12V-2 output over loaded| Load power >75W
0.00E+00| DC12V-2 output over current| Output current > 6Aor
short-circuit
0.00E+00| DC12V-2 input over current| Current > -1A
0.00E+00| System overloaded. DC output stop| Total power >380W at 3mins
0.00E+00| Inverter output overloaded| Power >300W at 2mins or power >450W| Recover by pressing any button
0.00E+00| Inverter output overcurrent| AC output short-circuit
0.00E+00| System overloaded, AC output stop| Total power >380W at 3mins

Frequently Asked Questions

1. How to check the state of charge?
   – The battery icon display on the LCD display shows the battery level and charge status.

2. How to use the product to charge other electronic devices?
   –  Check the user manual or search for information online to learn aboutthe charging parameters of the electronic devices you wish to connect.
   Check the power of each output port. For example, the maximum rated output power of the AC output port is 300W. This means that if the power of the connected electronic device exceeds 300W for a long time, the inverter will turn off theoutput.

3. What is the depth of discharge (DOD)?
   – To prolong the battery life, the product has a DOD setting to 90%, which means that only 90% of the battery capacity can be discharged, and retain 10% to avoid damage to the battery due to excessive discharge.

4. Can it charge and discharge simultaneously?
   – Yes, but it is not recommended to charge and discharge at the same time in order to protect the battery life.

5. Can it be charged by using 2 solar panels in series?
   – Yes, just make sure the total open circuit voltage (VOC) of the solar panels are less than 40V. Otherwise it may trigger the charging over-voltage protection or cause damage.

6. How to extend the using time of CPAP?
   – Recommend to turn off its humidifier, heater, and set a lower pressure.
   50Hz/60Hz frequency switching (factory setting: 60 Hz).
   Step 1: Press the power button to turn the product on, then press the DC and AC buttons at the same time.
   The LCD will illuminate and display the current frequency (50Hz or 60Hz). Release the button and continue to the next step.
   Step 2: Press and hold the DC button or AC button to select 50Hz and 60Hz. The frequency displayed on the LCD will change accordingly.
   Step 3: After selecting the desired frequency, press the DC button and AC button at the same time to complete the setting. Step 1 can be repeated to check the current frequency.
   Step 4: Reboot to use with new frequency.

7. Can the AC output power a refrigerator or air conditioner?
   – Workable for low power refrigerators. The starting power of refrigerators and air conditioners are generally 5~7 times more than the rated power, which easily triggers AC overload.

8. Can two power stations be used in parallel?
   – No.

Visit our website www.srportables.com for more information or contact our technical team on +61 3 8618 6984

References

• SR Portables | Hand-held Solar Generators | Victoria

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>