sudio N2Pro True Wireless Earphones Owner’s Manual
- June 10, 2024
- Sudio
Table of Contents
sudio N2Pro True Wireless Earphones
Package Content
- N2 Pro
- Charging cable
- Ear tip holder
- Warnings
- Owners manual
Operating Instruction
- Place earbuds in case
- Close lid
- Open lid & connect device
: l tap
: Tap 2x left
: Tap 2x right
Vol : Tap 3x right
Vol : Tap 3x left
- To turn Voice Assistant on/ off hold L side for 2 sec
- To turn ANC on/off hold R side for 2 sec
Accept calls: 1 tap
Hang up or reject calls: Hold button 2 seconds
- Put earbuds in case
- Hold button on case for 5 sec with lid open
- Light blink 2x
Use wireless charger or USB-C.
Amber/white light= charging. White light = charged.
LED blinks amber light when low battery
(0-25%), and white light between 26%-100%
Place earphones in charging case & close lid to turn off. Open the lid to turn
on.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>