Hill Laboratories IFC Next Generation Interferential Multi Wave Electrotherapy Device User Guide
- June 10, 2024
- Hill Laboratories
Table of Contents
Hill Laboratories IFC Next Generation Interferential Multi Wave
Electrotherapy Device
Product Information
The IFC (Interferential Current) device is a therapeutic device used for pain relief and muscle stimulation. It uses low-frequency electrical currents to stimulate the nerves and muscles in the affected area. The device has two outputs that can be used simultaneously for dual-channel treatment. The device also has an intensity control feature that allows the user to adjust the intensity of the electrical current based on the patient’s comfort level.
Product Usage Instructions
Follow the steps below to use the IFC device:
- Turn on the device by pressing the power button.
- The intensity level will blink. Tap the “Intensity” button and use the arrow buttons to adjust the intensity level to the patient’s comfort level.
- Tap the “Intensity” button again to lock in the intensity level.
- The time and intensity levels can be changed while the unit is running.
- To stop the treatment, press the power button to turn off the device.
- If you want to use both outputs at the same time, make sure both output cables are connected to the device before turning it on.
- If you turn off the device using the patient switch, both outputs will be stopped at the same time.
- For therapy accessories, visit HillLabs.com/shop or call 1-877-445-5020.
To turn on the IFC
- Turn switch to “ON” in the back of the unit
- Attach the electrode pads to the patient
- Hand Patient Shutoff Switch to the patient
- Select Quadpolar by tapping IFC. Use arrows to select from P01 – P06. When flashing, tap to select.
IFC Presets
- P01 Acute pain
- P02 Chronic pain
- P03 Edema 1 (1-30 Hz)
- P04 Edema 2 (1-10Hz)
- P05 Nerve Block
- Touch Start/Stop
- Time and intensity will be blinking
- Time is set at 10 minutes. To change, tap “Time” and use the arrows: then tap “Time” again to lock in.
- Intensity will blink. Tap “Intensity” and use the arrows to increase intensity to patient’s comfort. Tap “Intensity” again to lock in.
- Time and intensity can be changed while the unit is running.
To stop the treatment
- Hold the Start/Stop button for 2 to 3 seconds
To use both outputs
- Once Output 1 has been set, press and hold Output 2
- Repeat treatment selection as you did with Output 1. You may choose a completely different treatment mode and time.
- Once both modes are running, you may toggle between modes by pressing the desired output button. Press Output 1– time and intensity will be shown, then press Output 2 to see its settings.
- To stop both outputs, you must stop one at a time. Hold the Start/Stop for 2 to 3 seconds to stop the output that is presently selected. Now select the other output and hold the Start/Stop button again for 2 to 3 seconds.
If the unit is turned off using the patient switch, both outputs will be stopped at the same time.
1-877-445-5020.
References
Read User Manual Online (PDF format)
Loading......