Miootly 2700-5000K 6 Inch Recessed Lighting 12 Pack User Manual
- June 10, 2024
- Miootly
Table of Contents
2700-5000K 6 Inch Recessed Lighting 12 Pack
User Manual 2700-5000K
LED Recessed Light
User Manual
COMMON TROUBLESHOOTING
We are an LED manufacturer with 20-year experiences and According to our
statistics, 95% of customers’ problems are related to the method of
installation and the use of dimmer, which could be solved by customers
themselves. please read this introduction first, if you encounter any
problems.
Problems you may encounter
PROBLEM | POSSIBLE CAUSE | SOLUTION |
---|---|---|
Unlit | The wire falls off/loosens/breaks | Double check the connection of the |
wire Plug the wire hard into the hole of the plastic connector till the wire
end sticks out of the inside metal clip end.if the wire is too thick, peel off
the wire cover at least 10mm to make sure the wire is inserted firmly.
The connector is missing or the connector lacks metal shrapnel| Double check
the connector.
Voltage is too high| Work on 110-130 volts
Dim| The wire falls off/ loosens/ breaks| Double check the connection of the
wire.
Not setting the dimmer right| Double check the setting.
Mix the junction boxes(4″and 6″)| Check Voltage,9W for 4″and 12W for 6″
Compatible dimmer,but too many lights connect to one dimmer| Reduce the number
of lights connected to the one dimmer.(Total Power of the Lights 75% of the
Rated Power of the Dimmer)
Total brightness of the lights/house area:too small| Install more lights.
Recommended spacing for installation of 4lights:2-4ft (6″ights:5-7ft)
Flickering| the wire falls off/ loosens/ breaks| Double check the connection
of the wire.
not setting the dimmer right| Double check the setting.
mix the junction boxes (4″ rand 6″)| Check the Voltage,9W for rand 12W for 6″
(x)incompatible dimmer| Select a dimmer from the recommended dimmer list.
(V)compatible dimmer,but too many lights connect to one dimmer| Connect fewer
lights to the one dimmer. Total Power of the Lights75% of the Rated Power of
the Dimmer)
high-power electrical appliances on the same circuit| Remove and set them
further away from each other.
Buzzing noise from dimmer/ junction box/ circuit breaker (>20Db)|
(x)incompatible dimmer| Select a dimmer from the recommended dimmer list.
(V)compatible dimmer,but too many lights connect to one dimmer| Reduce the
number of lights connected to the one dimmer(Total Power of the Lightss75% of
the Rated Power of the Dimmer)
(x)incompatible circuit breaker| A.Mechanical circuit breaker:replace a
compatible dimmer.
B.Electronic control circuit breaker:replace the circuit breaker first.
high-power electrical appliances on the same circuit(radio, air conditioners,
refrigerators, etc.)| Remove and set them further away from each other.
Contact US
Contact by “Ask a question”on the “Miootly “Seller Page.(7x24H)
Because Amazon’s information system sometimes can’t successfully receive and
send information, in which case you may not receive our response. We wil never
be able to reply to your inquiry. If you find that we have not responded to
you within 24 hours please send us an e-mail.
Contact via Email: miootlylights@gmail.com(7x24H)
SAFETY INSTRUCTION
Motley’s recessed lighting is certfied by ETL & Energy Star of a high
standard. This canless LED recessed light is C rated, with more convenient and
secure UL. connectors. But to reduce the risk of death, personal injury or
property damage from fire, electric shock and other hazards, please read all
warnings and instructions included with and on the fixture box and all fixture
labels. please review instructions carefully before proceeding.
WARNING
RISK OF ELECTRIC SHOCK
- All electrical connections must be in accordance with local and National Electric Code(N.E.C.) standards.
- Consult a qualified electrician if you are unfamiliar with proper electrical wiring connections.
- Turn off the switch and circuit breaker before installing this LED light.
- Do not alter, re-locate or remove wiring.
- Double-check all connections to be sure they are tight and correct.
- Verify that supply voltage is correct by comparing it with the luminaire label information.
RISK OF FIRE
- Keep combustibles and other materials that may burn away from lights.
- The maximum ambient temperature is 104F. Do not operate fixture at temperatures higher than it
CAUTION
RISK OF INJURY
- The knockouts may be sharp. Wear gloves and safety glasses at all time when removing luminaire, installing or performing maintenance.
- Avoid direct eye exposure to the light source while it is on.
- Wear rubber-soled shoes and work on a sturdy wooden ladder.
RISK OF BURN
- Do not touch enclosure or light source.lt is normal of the luminaire surface heating up during work.Allow lights to cool before handling
**RISK OF PRODUCT DAMAGE**
- lectrostatic Discharge(ESD): ESD can damage LED fixtures. Personal grounding equipment must be worn during all installation or servicing of the unit.
- Do not touch individual electrical components as this can cause ESD, shorten lamp life, or alter
- performance.Do not mix our product with other products including Miootlys light. eg.4″and 6″). Mixing junction box of different power wil lead to the destruction of the product.
- Do not let the product directly contact with water. Our product is damp-rated but it is not water-proof
- Do not make or alter any open holes in an enclosure of wiring or electrical components
- Never connect components under load.
- Please make sure that all wires in and out are wired firmly and sufficiently. If not. there wil be a flickering issue or the light will just stop
IMPORTANT
- Our temperature has been strictly monitored. But the temperature will be slightly different with varied monitors Please test them before installation up in the ceiling wall and see the color if it meets your needs
- If there is anything wrong with our lights please see the Troubleshooting page. If you could not find an answer in that page please contact us
ROUTINE MAINTENANCE
- Please make sure the power is off before maintenance
- To avoid any damage to the product,please do not use any chemical solvents during the routine maintenance.
- To ensure better lighting. please clean the lamp at regular intervals.
LIMITED WARRANTY
This product is warranted to be free from defects in workmanship and materials
for up to 5 years from date of purchase.lf it fails to do so, please contact
the Customer Service Team
STEP – BY STEP INSTALLATION
TOOLS REQUIRED : Saw, Measuring Tape, Electrical Wiring(The wire should
be AWG14-18 for application to connect the fixture), Safety glasses and
gloves.
Cut a hole with 1:1 size of the cutting template
Open the junction box and remove knock-out on the side.
Run wire from the power source through the hole.
Use the connector to tuck the wires according to the color. flip the switch on
the side of the junction box to locate the setting that you like.
Connect(tightly by hand) the junction box to the light panel.
Put the box in the ceiling hole. Push up the spring clips.
Push the light in to the ceiling and power on.
SPECIFICATIONS
SPECIFICATIONS | 4″ | 6′ |
---|---|---|
Voltage | 120V | 120V |
Wattage | 9W | 12W |
Current | 0.075A | 0.1A |
Power Factor | 0.9 | 0.9 |
LIGHTING PERFORMANCE
Lumens | 750LM | 1050LM |
---|---|---|
Equivalency | 75W | 110W |
Color Temperature | 2700K-5000K | 2700K-5000K |
Color Rendering Index(CRI) | >80 | >80 |
Beam Angle | 120° | 120° |
Dimmable | Yes | Yes |
Effciency(Im/w) | 83Im/w | 87.5Im/w |
ENVIRONMENT
Operating Temperature | 14F to 104F | 14F to 104F |
---|---|---|
Suitable Damp Location | Yes | Yes |
Fits Around Joists | Yes | Yes |
Fits Soffit to Double Drywall Ceilings | Yes | Yes |
CONSTRUCTION
Housing Material | Aluminum+PC | Aluminum+PC |
---|---|---|
Weight | 300g | 410g |
LIFESPAN
Average Life(hours) | 50000+ | 50000+ |
---|---|---|
Warranty | 5 years | 5 years |
Switching Time | >40000 | >40000 |
DIMMER COMPATIBILITY GUIDE
Brand | Model | Star Rating |
---|---|---|
LUTRON | DV-600P-WH S-600P-WH CTCL-153P-WH DVCL-153P-WH LG-603PH-AL TG600PH-WH | |
LEVITON | MACL-153M-WH,6631,6674,6683,1PL06-10Z,6684,6672 | |
COOPER | 9534WS-K,S106P,DLCO3P,9573SG | |
ENERLITES | 50321 |
The number of lights that a dimmer can control in one circuit
- 6″:the dimmer rated power(wattyl2watte75%
- 4:the dimmer rated power(watty9watts’75%
CUSTOMER SERVICE
12 HOURS QUCIK RESPONSE
If there is any problem with our light,please refer to the Trouble shooting
page on the back. If you still could not fix this, please contact us
immediately. It doesn’t matter if you have installed the product, we will
respond within 12 hours
30-DAY MONEY-BACK
For 30 days after the date of purchase, return your Miootly productand receive
a full refund for ANY reason.
5-YEAR WARRANTY
For 5 years after the date of purchase,if there is any issue with the
product.we will send a new product for free or a full refund.(no need to
return the purchased product)
Under most conditions, we will not require you to return the purchased items.
Sure, if you would return the defective ones) to us, we will be very happy for
that would help us to make continuous
Free Replacement No Repair
After the buyer purchases the product, if the product has a quality problem
within the scope of the seller’s warranty service validity period then will
replace the buyer with a new product for free.
Friendly Reminder
Please rest assured that our service aim is to make customers 100% satisfied.
If there is any problem,please contact us as soon as possible.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>