HABYS Four Part Folding Mattress 200x120x3 Shiatsu Rehabilitation Mattresses Instruction Manual
- June 10, 2024
- HABYS
Table of Contents
Four Part Folding Mattress 200x120x3 Shiatsu Rehabilitation
Mattresses
Instruction Manual
Thank you for choosing HABYS products and congratulations on your purchase.
We recall that the proper use and maintenance of the products ensure full
satisfaction of their use for many years.
User Manual number: 030/2022
User Manual release date: 1.06.2022
APPLICATION
Using the mattress gives the best results during general rehabilitation and in certain types of massage treatments. It is particularly recommended for:
- general and corrective rehabilitation of children and adults,
- active and passive exercises,
- corrective gymnastics,
- exercises and amusement in nursery schools,
- certain types of massage treatments.
DESIGN
Mattresses made of hard polyurethane foam, covered with a coated knit. Three, four – part folding mattresses also have a Velcro securing and carrying handles.
ACCESSORIES
- Carrying CasePokrowiec for Three – Part Folding Mattress (Fig. 1.1)
- Carrying CasePokrowiec for Four – Part Folding Mattress (Fig. 1.2)
MAINTENANCE AND CLEANING
Eco-leather, leatherette. Clean with a solution of a mild detergent (soap, shampoo) in warm water by means of soft sponge. It is forbidden to: use pastes, wax, dissolvents, cleaning agents for natural leather; water cleaning, ironing, contact with heated surfaces (heater, radiator), pierce the material with sharp objects.
DISINFECTION
Disinfect when necessary and sporadically.
EXPLOITATION REMARKS
- Mattresses are intended for use inside the dry and closed rooms and for the treatment of one person only at a time.
- It is unacceptable to shift the mattresses along with a patient on it.
- If the patient is laid on the mattresses without clothing, the therapist should use disposable liners or disinfect the table.
- Mattresses should be used and stored far away from the direct sources of fire and heat.
- Mattresses should not be exposed to long-term solar radiation. It may cause discolouration of the table upholstery.
- Mattresses should be used in accordance with the instruction manuals.
- It is necessary to get acquainted with the terms of warranty and observe them.
- Only after meeting the above recommendations there are no contraindications to use the product.
- Each serious incident related to the device should be reported to the manufacturer and the competent authority of the Member State in which the user and/or patient is established.
TECHNICAL DETAILS
Mattress
One- Part Mattress| Length
195 cm| Width 100 cm| Height
5 cm| Weight
6,2 kg| Dimensions after folding
---|---|---|---|---|---
195 cm| 100 cm| 10 cm| 11,2 kg|
Two – Part Folding Mattress| 170 cm| 65 cm| 5 cm| 3,5 kg| 85x65x10 cm
Three – Part Folding Mattress| 195 cm| 85 cm| 5 cm| 5,45 kg| 85x65x15 cm
195 cm| 100 cm| 15 cm| 6,8 kg 100x65x15 cm
Four – Part Folding Mattress| 200 cm| 120 cm| 3 cm| 5,4 kg 120x50x12 cm
MEANING OF PICTOGRAPHS
| Attention
---|---
| Maximum load
| Medical device
| Keep dry during storage
| CE mark – product compliance with the requirements of the Medical Devices
Regulation (MDR) 2017/745/EU
| Date of manufacture
| Manufacturer’s name and address
| See the instruction manual for use
WARRANTY CONDITIONS
- For the purposes of the guarantee:
- “Manufacturer” refers to HABYS Spilka z ograniczonq odpowiedzialnogciq (Limited Liability Company) with its registered seat in Jaslo, ul. Produkcyjna 16, 38-200 Jasfo, entered into the Register of Entrepreneurs kept by the District Court in Rzeszow, XII Commercial Division of the National Court Register, with the assigned KRS number: 0000513317, with the share capital in the amount of PLN 750.000 (ten million seven hundred fifty thousand zlotys), the capital has been fully paid up, NIP: 6852208438, REGON: 180186290.
- “Buyer” refers to the final Buyer of the equipment, manufactured by the Manufacturer, including both the consumer and the entrepreneur.
- “Distributor” refers to an entity that, under an agreement with the Manufacturer, sells the Equipment in a designated area.
- “Authorized Service Centre” refers only to a service held by the Manufacturer or a service indicated by the Manufacturer and held by its Distributor,
- “Equipment” refers to a movable item, manufactured by the Manufacturer, being the subject of the sales and to which the said warranty applies.
- The manufacturer ensures good quality and efficient operation of the equipment for which the warranty card has been issued for the period of: 2 years.
- The guarantee repair does not include the activities provided for in the manual, which the Buyer is obliged to perform on his own (installation of the Equipment, maintenance of the Equipment, etc.).
- Liability under the guarantee covers only defects resulting from causes inherent in the Equipment., In particular, the guarantee does not cover any damage resulting from improper or inconsistent use, storage, maintenance or transport of the Equipment, as well as colour differences between the parts exposed and not exposed to solar radiation, the influence of chemical or abrasive agents, atmospheric pollution or accidental punctures and abrasions, the presence of stains or rings from greasy or dying substances (fats, creams, lotions or oils), permanent staining with dyes such as inks, permanent markers or other nonpermanent dyes used in the production of clothing (e.g. dyes used to make blue jeans).
- The guarantee does not cover any mechanical damage to the Equipment.
- The buyer loses the guarantee rights in the event of:
- the Manufacturer states that the Equipment was repaired by entity other than the Authorized Service,
- making any design modifications to the Equipment without the prior written consent of the Manufacturer,
- using the Equipment contrary to its intended use,
- using the Equipment after revealing any defect in it.
- Regardless of the loss of the guarantee rights, described above, in point 6, the Manufacturer shall not be liable for any damage to property or caused to third parties, which may be caused by the use of the Equipment covered by the guarantee.
- The guarantee does not exclude or limit the rights resulting from the warranty for defects. Exercising the rights under the guarantee does not affect the seller’s liability under the warranty for defects. If the Buyer exercises the rights under the guarantee, the time limit for the exercise of the rights under the warranty for defects is suspended on the date the Manufacturer is notified of the defect. The period runs further from the date of the Manufacturer’s refusal to perform the obligations arising from the guarantee or the ineffective expiry of the time for their performance.
- The scope of the guarantee coverage is limited to the territory of the country in which the Equipment was sold.
- The Manufacturer shall perform its obligations under the guarantee (removal of defects or damage to the structure of the Equipment arising from reasons inherent in the Equipment, and disclosed during the guarantee period) free of charge within 14 days from the date of delivery of the Equipment to the Manufacturer or the Authorized Service Centre. If the repair of the Equipment cannot be performed within the above-mentioned period, the Manufacturer shall inform the Buyer of the above, and also indicate the reasons for the delay and the expected date of fulfilment of the recognized guarantee request.
- The use of the guarantee rights requires the total (cumulative) fulfilment of four conditions:
- presenting a VAT invoice, receipt or other proof of purchase of the equipment to the Manufacturer, photographic documentation of the defective Equipment, together with a brief description of the reasons for submitting a guarantee claim,
- reporting the defect within 14 (fourteen) days of its detection,
- delivering the Equipment in original packaging at the expense of the Manufacturer, to the address indicated above in the guarantee card or to the address of the Authorized Service Centre,
- designation of the place where the Manufacturer delivers the equipment after repairing it (limited to the country in which the Equipment was purchased).
- The guarantee period is extended for the duration of the repair, starting from the date of delivery of the Equipment to the Manufacturer or to the Authorized Service Centre, to the date on which the Equipment was returned to the Buyer.
- The responsibility of the Manufacturer or the Authorized Service Centre is to define the scope and the method of repairing the Equipment.
- The guarantee is limited to the repair of the Equipment. The Manufacturer reserves the right to replace the Equipment with a non-defective one, if the repair exceeds the price of the Equipment indicated in the proof of purchase. Under the guarantee, the Buyer shall not be entitled to demand that the Equipment be replaced with a new one. The guarantee, in particular, does not cover liability for losses or damages incurred by the Buyer in connection with the fact that one is not able to use the Equipment.
- The Manufacturer shall not be liable for any damage to the Equipment caused during the performance of the transport service by the delivery company until it is collected by the Manufacturer from the delivery company.
- If the shipment of the Equipment was ordered by the Manufacturer, the Buyer is obliged to check the technical condition of the Equipment upon its receipt. If the Buyer finds that the Equipment has been damaged during the transport, the Buyer is obliged to:
- immediately, not later than within 3 days from the date of receipt of the shipment, notify the Manufacturer of any damage to the Equipment that occurred during transport, in order to enable the Manufacturer to submit a complaint to the delivery company and pursue related claims,
- provide the Producer with a complaint report drawn up between the Buyer and the delivery company.
- The guarantee regulations contained in this document are the sole and exclusive guarantee rules for HABYS limited liability products.
Other language versions available here:
www.habys.com/warrantymanuals
HABYS Sp. z o.o.
ul. Produkcyjna 16, 38-200 Jasło, PL
tel.: +48 887 766 115, info@habys.pl
www.habys.pl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>