MiTCEnT MT2002B 4 In 1 Cordless Vacuum User Manual
- June 10, 2024
- MiTCENT
Table of Contents
MiTCEnT MT2002B 4 In 1 Cordless Vacuum
These warnings apply to the machine, and also where applicable, to all tools, accessories, chargers or mains adaptors.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY:
- Do not allow it to be used as a toy. Close attention is necessary when used by or near children. Children should be supervised to ensure that they do not play with the machine. (Do not allow children to ride on or play with the product.)
- Suitable for dry location ONLY. Do not use outdoors or on wet surfaces and do not expose to water or rain.
- Do not handle any part of the plug or machine with wet hands.
- If the machine is not working as it should, has received a sharp blow, has been dropped, damaged, left outdoors, or dropped into water; do not use it and contact Mitcent Support.
- Do not stretch the cord or place the cord under strain. To avoid damage, remove the plug by grasping the plug, not by pulling the cord. Keep the cord away from heated surfaces.
- Do not allow the vacuum cleaner to run unattended at any time. Use the vacuum cleaner only for its intended purpose as described in these instructions.
- Do not use the vacuum cleaner without a dustbin.
- Empty the dustbin before it is full to maintain the highest efficiency.
- Do not use the vacuum cleaner to pick up matches, live ashes, or cigarette butts. Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolor the plastic parts of the unit.
- Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the vacuum’s parts.
- Do not block the suction or the exhaust port.
- The battery must be removed from the main unit before cleaning or performing maintenance on the vacuum.
- Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts, such as the brush bar. DO NOT point the hose, wand or tools at your eyes or ears or put them in your mouth.
- Do not use it to suction up water.
- Do not immerse in water for cleaning.
- This product is intended for household use only. Do not use this product for heavy-duty cleaning, commercial cleaning, industrial cleaning, or cleaning outdoors, especially on stone or cement. Do not use to pick-up chalk powder in and around billiard tables or in hospital aseptic rooms.
- Do not pick up toxic materials (chlorine bleach, ammonia, drain cleaner, etc.).
- Do not use the vacuum cleaner in an enclosed space filled with vapors given off by oil-based paint, paint thinner, moth-proofing substances, flammable dust, or other explosive or toxic vapors.
- This machine is not intended for use by persons (including children) with reduced physical, sensory, or reasoning capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the machine by a person responsible for their safety.
- Use only as described in this Mitcent Operating Manual. Do not carry out any maintenance other than that shown in this manual, or advised by the Mitcent Support.
Briefing:
MT2002B is a real cyclone model that features an exquisite appearance,
graceful in color, and reasonable in internal structure. This is a wireless
rechargeable, handheld, cyclone, bagless vacuum cleaner with low noise and a
high-efficiency act. It’s suitable for different places. It makes your life
more comfortable if you choose to use this machine.
Main Parts Identifications
- Tube release button
- Button(Detach body)
- Battery Indicator
- Speed control button
- Charging port
- On/off button
- Battery pack release button
- Dust cup
- Dust release button
- 2-in-1 crevice nozzle
- Aluminum tube
- Motorized floor brush
- Small brush
- Charger
- Transfer head
- Sofa brush
- Crevice nozzle
- 360-degree rotating square brush
Unpacking
Unpack the vacuum cleaner and all its parts, and compare them against the list below. Do not discard the carton or any packaging materials. Please call 1-800-791-9458 or E-mail us at support@amerisuninc.com if any parts are damaged or missing.
Including:
Cordless vacuum cleaner/Battery pack/Motorized floor brush/Metal tube/2in1
extended brush/Small brush/Charger/Wall mounted bracket/Screws/Transfer
head/Sofa brush/Crevice nozzle/360-degree rotating square brush.
Cautions
For the sake of safety, comply with the following specifications.
-
Don’t absorb the burning cigarette.
-
Don’t absorb water and other liquid.
-
Don’t absorb sharp things or too heavy things.
-
Don’t place it near the heat source.
-
Maybe leaking happened from the battery under extreme conditions.
If the leaking liquid touches the skin, please wash it immediately with soapy water or vinegar; and if the liquid runs into your eyes, pls wash with water immediately for 10 minutes at least and see a doctor.- Never use this battery on other products or use another battery on this one.
- This Li-ion battery should be recovery & disposed of in the right way.
-
Pls, charge the vacuum cleaner with the attached adaptor in order to avoid damage to the battery, product, or consumer.
- Make sure the product is switched off before charging.
- Make the battery run out all at the beginning 2-3 times, then charge until the battery is full. (About 4.5 to 6 hours.)
- To prevent deep discharge, the battery must be charged every 3 months even when not in use. Failure to follow this procedure will void the warranty on the battery. Our technical service can determine whether a battery is deeply discharged.
How to use
Preparation
WARNING:
-
Do not charge the product near a window, heater, toilet, bathroom, etc.
-
If there is dust, water, etc. on a pin or contact point of the power plug, wipe them carefully.
-
Do not pull the cord and do not touch the plug with wet hands.
-
Do not use a damaged power plug, battery charger, or loose power outlet.
-
Do not touch the charging terminal of a vacuum with chopsticks, metal screwdrivers, forks, knives, etc.
-
Before ejecting the battery, the product must be turned off. (If the battery is forcibly ejected while the vacuum is operating, the vacuum can malfunction.)
-
Be careful not to drop the battery. If you do, you can injure yourself or damage the battery.
-
If there is a gas leak or combustible spray is used, do not touch the power outlet and open the window for ventilation.
-
The vacuum cleaner cannot be used while it is charging.
-
Do not pull or carry the charger by a cord, use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. Do not run the appliance over the cord.
-
When the battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws, or other small metal objects, that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire.
-
Do not operate any machine with a damaged cord or plug. Discard the machine or return it to an authorized service facility for examination and/or repair If the supply cord is damaged it must be replaced by Mitcent, its service agent, or a similarly qualified person in order to avoid a hazard.
-
Battery Charging.
Make sure the adaptor’s technical data meet the electrical source, and connect the adaptor and main body. Insert the adaptor into the socket. Three blue lights take turns to light up indicating that the machine is charging, and all three lights are on, indicating that the machine is fully charged.
Note: After charging, it is better to continue charging for another 15 to 30 minutes to ensure the battery is fully charged.
Note: Do not charge the battery immediately after running out of power. Wait for the battery pack to cool down before connecting the charger. -
Fix the battery pack to the main body.
-
As shown in the figure, connect the main body and aluminum tube lock button up. Another head of the aluminum tube connects the floor brush/crevice nozzle.
-
As shown in the figure, the crevice nozzle/floor brush connects the main body.
-
As shown in the figure, the crevice nozzle/floor brush connects the main body.
-
Install Wall mount bracket
The first step is, Make a mark on the wall according to the position of the screw hole of the wall mount bracket, and then drill three $8 holes on the wall with a drilling machine, and install the expansion screw.
In the second step, Attach the wall mount bracket to the wall and align the three holes with the expansion screws, then tighten with the screws.
The third step is Mount the machine into the wall mount bracket.
Using
WARNING:
- Do not pick up hard or sharp objects such as glass, nails, screws, coins, etc.
- Do not use without a filter in place. Only use the device with a dry and correctly installed cyclone insert and HEPA filter as well as a dust container.
- When servicing the unit, never put fingers or other objects into the fan chamber in case the unit accidentally turns on.
- Do not put any objects into openings. Do not use it with any openings blocked. Keep openings free of dust, lint, hair, and anything that may reduce air flow.
- Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
- When assembling the vacuum, be careful not to catch your fingers or hands in the movement fold of the handle.
- Do not use the vacuum cleaner on objects that can be easily scratched (monitors, stainless steel appliances, etc.).
- Only operate the vacuum cleaner with the correctly installed cyclone insert and HEPA filters. Do not use without filters in place.
- Use extra care when cleaning stairs.
- Do not use the vacuum cleaner in direct sunlight or high heat.
- Do not use the vacuum cleaner to pick up spilled beverages or pet waste.
Press the on/off button one time, and it starts to work. Power can be adjusted by a speed control button.
Note: Time of use.
Cleaning the dust cup
- Methadone: Press the dust release button, and open the bottom cover to empty the dust. After this, close the bottom cover.
- Method two: Press the dust cup release button, and take out the dust cup as shown in the picture. Then Rotate the dust cup cover to unlock the mark, clean the wind-in sponge, HEPA (or replace new), and center the filter, after cleaning turn the mark on the cover aim at the mark on the cup, and fix these two parts.
Maintenance
-
The filter should be washed or replaced in order to avoid blockage.
(Attention: Don’t wash the filter in the washing machine or dry it with electrical heaters please re-fix it after drying the filter in air.) -
Don’t clean the outer shell of the cleaner in petrol oil-like liquid rub it with water and soft soap liquid.
(Attention: Don’t clean the machine with a cloth full of water. Don’t let the water flow into the vacuum cleaner.) -
Clean the brush
The first step is, Push back the button on the roller brush cover and remove the roller brush cover.
In the second step, Lift the rolling brush upward to clean up tangled hair and other garbage.
The third step, After cleaning, install the rolling brush components and rolling brush cover plates in place. Please note that the rolling brush can be washed, but be sure to wait for the rolling brush to dry before loading it into the machine.
Warranty Information
Thank you for your purchase. This product is warranted against defects in materials and manufactures for a period of 24 months from the date of original purchase, provided that it is used in accordance with the provided instructions and the defect is not a result of misuse, neglect, accident alteration, or improper installation.
If you experience any faults or defects with this product, we request that you
contact our authorized Service Centre on the first instance by calling,
writing, or emailing:
support@mitcent.com. http://www.mitcentcom/.
Please note:
Proof of purchase is required to establish the date and location of
purchase, for warranty purposes. We recommend that you retain your receipt as
proof of purchase.
- Proof of purchase is required to establish the date and location of purchase, for warranty purposes. We recommend that you retain your receipt as proof of purchase.
- As Mitcent® does not undertake that repair facilities and parts will be available for the product the decision to repair replace or refund the product will be at the sole option of Mitcent® or its Authorised Service Centres.
- The product will be at the owner’s risk whilst in transit to or from
- Mitcent® or its Authorised Service Centres.
- Mitcent* and its Authorised Service Centres may charge you for labor; parts, transportation, and handling costs for work done when the product is found to be in working order.
- Mere postage/delivery of the item is deemed necessary; the owner will bear the expense of transporting the item to Mitcent® or its Authorised Service Centre; return freight will be covered by Mitcent or its Authorised Service Centre.
Warranty Card
Contact Information
support@mitcent.com.
www.mitcent.com.