sudio A1 Wireless Headphones Owner’s Manual

sudio A1 Wireless Headphones

Product Information

The Studio A1 is a wireless earbud product that comes with a charging case. It has a battery indication feature that shows the battery level through LED lights. The LED blinks when the battery is low (0-25%), and white light shows between 26%-100%. It can be charged using USB-C and has a factory reset option that can be done by holding the button on the case for 5 seconds with the lid open.

Product Usage Instructions

1. To check the battery level, look at the LED lights on the earbuds. If the LED blinks, it means the battery is low (0-25%). If there is a white light, it means the battery level is between 26%-100%.
2. To charge the earbuds, use the provided USB-C cable. The white light on the earbuds shows the charging level.
3. To do a factory reset, put the earbuds in the case and hold the button on the case for 5 seconds with the lid open. The LED lights will blink 2 times.

Battery indication

LED blinks when low battery (0-25%), and white light between 26%-100%

Charging

Charge with USB-C. White light shows the charging level.

Factory reset

1. Put earbuds in case
2. Hold the button on the case for 5 sec with the lid open
3. Light blink 2x

Included in the box

1. A1
2. Charging cable
3. Warnings folder
4. Owners Manual

Pairing to a device

1. Remove protective stickers
2. Place earbuds in the charging case, and close the lid.
3. Open the lid and remove the earbuds from the case, and connect them to the device.

Playback operations

• Play and pause 1x click ( )
• Next track 2x clicks ( )
• Previous track 2x clicks ( )
• Volume up 3x click ( )
• Volume down 3x click ( )

Phone call operations

• Accept calls: 1 taping up or reject calls: Hold button2 seconds

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF warning statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Sudio Help Center

www.sudio.com/helpcenter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>