Hoover UH77110 WindTunnel Tangle Guard User Guide
- June 11, 2024
- Hoover
Table of Contents
Hoover UH77110 WindTunnel Tangle Guard User Guide
GETTING STARTED
Fully assemble product prior to use.
-
Insert the handle into the wand. You will hear a click when inserted properly
-
Insert the wand firmly into the unit.
-
Insert the lower end of the hose into the hose port. Then insert the upper end into the handle port.
USING YOUR PRODUCT
-
Plug in, then push the Power Button on the shoulder to power ON/OFF.
-
Hold for 3 seconds to turn brushroll off.
-
For above floor cleaning, release handle for up close cleaning.
-
For above floor cleaning, release wand for hard-to-reach cleaning.
CLEANING THE FILTER
-
Remove the dirt cup, then remove the filter from the dirt cup lid using the tab.
-
Rinse the filter with water until the water runs through clear.
-
IMPORTANT: Allow the filter to air dry for 24-48 hours.
TOOLS FOR EVERY MESS
Turbo Tool
Remove pet hair and dirt from upholstery, stairs, and more.
LED Crevice Tool OR Crevice Tool
Clean crevices and hard to reach areas. Attach at the end of the wand or
handle to clean up high or down low.
2-in-1 Dusting Brush & Upholstery Tool OR Dusting Brush
Remove pet hair, dust, and dirt on upholstery, stairs, baseboards, and more.
Not all tools included on each model.
Documents / Resources
|
Hoover UH77110 WindTunnel Tangle
Guard
[pdf] User Guide
UH77110 WindTunnel Tangle Guard, UH77110, WindTunnel Tangle Guard, Tangle
Guard, Guard
---|---