mifa Tango Portable Bluetooth Speaker Owner’s Manual
- June 11, 2024
- MiFa
Table of Contents
Tango Portable Bluetooth Speaker
Owner’s Manual
Tango Portable Bluetooth Speaker
| Speaker: | full range 050mm, bass radiator 2 x (52mmX32mm) |
|---|---|
| Output power: | 10W RMS (THD< 1%) |
| Frequency response: | 70Hz-20kHz (-10dB) |
| Signal-to-noise ratio: | 290dB |
| Battery type: | Li-ion 3.65V 5000mAh/18,.25Wh |
| Charging time: | about 3 hours (5V/3A) |
| Run time: | about 25 hours (depending on volume, audio content, and lighting) |
| USB-C reverse output: | 5V/1A |
| Light emitting unit: | 3535 LED with monochromatic temperature |
| Lighting color temperature: | 6000k |
| Brightness: | 200LM |
| Bluetooth version: | 5.3 |
| Micro SD: | Support MP3, WMA, WAV, FLAC, APE |
| Product specifications: | W118mm x H135mm x D43.5mm |
| Product net weight: | <0.39kg |
| Protection function: | IP67 dustproof and waterproof, drop-proof |
| Operating temperature: | -15°-45° |
Package contents.
Tango speaker 1 unit
Quick Start Guide 1 copy
Safety warning 1 copy
Charging cable plc.
Hanging strap 1pc
Carabiner clip 1pc
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2} this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur ins particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver,
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
The device has been evaluated te meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
MIFAINNOVATIONS LLC
www.mifa.net Made in China
Copyright © MIFA. Alt rights reserved.
MIFA, the MIFA logo and other MIFA marks are all owned and registered by MIFA
INNOVATIONS LLC.
All other trademarks are the property of their respective owners. The
information contained here is subject to change without prior notice.