ELERA G-427B Blood Glucose Monitoring System User Guide
- June 11, 2024
- ELERA
Table of Contents
- How to Set System Date and Time
- How to Set Unit
- Product Component
- Service and Quality Assurance
- How to Read History Records
- Steps to Measure Blood Glucose
- Step 1: Preparation
- Step 2: Install a lancet into the lancing device.
- Step 3: Install a Test Trip into the machine.
- Step 4: Take blood sample
- Step 5: Measure and read results
- Step 6: Handling lancet and test strips
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
ELERA G-427B Blood Glucose Monitoring System User Guide
How to Set System Date and Time
How to Set Unit
Unit Setting Interface
Product Component
Notice
- The machine can only be used with ELERA G-427B test strips.
- When you replace the batteries, the History Records and Measurement Unit will be retained, but you need to reset the date and time.
Service and Quality Assurance
We offer a one-year warranty on our products. If you have any questions,
please contact us by email: [email protected]
You can also send us an email by scanning this QR code.
How to Read History Records
Step 1. When the machine is off, press “M” button to enter Memory Mode. Step 2. Press “M” button to go through each record in turn.
Memory Mode Interface
History record details
Steps to Measure Blood Glucose
You can watch the video of using this machine by scanning the QR Code.
Step 1: Preparation
-
Install the battery
-
Set the time and units
-
Wash and dry your hands. of the system.
Step 2: Install a lancet into the lancing device.
-
Remove the lancing device cap.
-
Insert a lancet into the lancing device.
-
Twist off the safety cap and put aside,
-
Reinstall the lancing device cap. don’t discard, it will be used later.
Step 3: Install a Test Trip into the machine.
Step 4: Take blood sample
-
Adjust the puncture depth: 1 is shallow, 5 is deep
-
Pull back the cocking barrel until you hear a click.
-
Wipe the finger with alcohol. Holding the lancing device against the side of the finger, press the release button.
-
Wipe away the first drop, and use the second to test.
Step 5: Measure and read results
-
Apply blood to the sample area of the test strip.
-
After 5 seconds, the result will display.
Step 6: Handling lancet and test strips
-
Test strip ejection.
-
Put the protective cap on the lancet tip.
-
Lancet ejection.
