TOSUNY EM4100 Handheld RFID Writer User Manual
- June 6, 2024
- TOSUNY
Table of Contents
125KHz RFID Re-write
User Manual
- Support Em4100
- Support Em4100/HID/AWID
- EM 410
- EM 410/HID/AWID
Remark:
How to distinguish two device listed above?
(1)The device beep 2 times when power on is supported EM4100
(2)The device beep 3 times when power on is supported EM4100, HID, AWID
This device is used to clone a 125KHz RFID card. It can clone Em4100, HID, AWID so you should reference the device model when you work. It’s very easy to use.
Parameter
| Frequency | 125KHz |
|---|---|
| Power | 2 AAA battery, it can used 20,000 times |
| Distance | _25mm(Keyfob) 5_60mm(Card) |
| Size | 7111731mm |
| Supported blank tag | T5577,EM4305 |
How to clone
- Push the power switch on the right of the device,it will beep two or three times, and LED is on mean it works,if not restart, please.
- Put the mother card near the antenna left of the device, and then press the READ button, the device will beep and the LED is on when read successful,if beep 2 times go to step3, if beep 3 times go to step 4, click READ again if it doesn’t beep.
- Change a new blank card as T5577/EM4305, then press WRITE button, when beep and PASS LED is on mean clone successful, if it doesn’t beep and light please write again.
- Change a blank T5577, then press the WRITE button, when beep and PASS LED is on mean clone successful, if it doesn’t beep and light please write again.
- Repeat step 3 or step 4 if you want to make more same ID card.
- Switch off to save power.
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.