Swim Fun FX2 2.0 Frisbee Pool Robot User Manual

Swim Fun FX2 2.0 Frisbee Pool Robot

Product Information

• Manufacturer: Swim & Fun A/S
• Contact: info@swim-fun.com
• Website: swim-fun.com
• Model Number: ART. 1961

Product Features

• Efficiently cleans pool floors and walls
• Filter capacity of approximately 42 L/min with a filtering speed of approximately 16 m/min
• Battery capacity of 2500 mAh with a charging time of 6-8 hours
• Drives for 40-60 minutes per cycle with a wheel angle adjustment feature
• IPX8 rated for water resistance and can be used in a maximum water depth of 2 m

Product Usage Instructions

1. Before using the FRISBEE FX2 2.0 POOL ROBOT, read the user manual carefully and follow all safety instructions.
2. Place the pool robot in the pool and connect the adapter to a power source with an input voltage of 100 V AC-240 V AC.
3. Charge the robot for 6-8 hours until fully charged.
4. Turn on the robot using the power button.
5. The robot will start moving around the pool floor and walls, cleaning as it goes.
6. Adjust the wheel angle as needed for optimal cleaning performance.
7. When the robot is finished cleaning or the battery runs out, turn off the power button and remove the robot from the pool.
8. Rinse the filter and clean the robot before storing it in a frost-free location for the winter season.

Important Precautions

• Please read this manual carefully, and use the cleaner according to the manual. We are not held liable for any loss or injury caused by improper use.

• Use the accessories recommended or sold by the manufacturer only.

• This model applies to swimmingpools with a flat floor.

• Please do not allow children to ride on it or play with it as a toy.

• If the power line is damaged, it must be replaced by a certified professional.

• Never power on the cleaner when it is out of the water.

• The power line must be connected to a leakage protected and earthed socket when charging.

• Do not operate the cleaner when there are people in the pool.

• Always clean and wash the filter tray after use.\

• Power off the cleaner when maintaining, cleaning or not using it.

• Store the pool robot in a cool, frost-free and ventilated location out of direct sunlight.

• The cleaner should be stored in a cool place when charging, and not covered
  with anything to prevent the damage of internal electrical components caused by overheating.

• Only professionals can disassemble the sealed driving kit of the cleaner.

• Do not operate while pool filter is running.

• The cleaner should be charged and discharged every three months if it needs to be stored for a long time to maintain battery life. Please use the original and authorized power adapter only.

• Do not use or store the cleaner near any heat source.

Introduction

The robotic pool cleaner Frisbee is a new type of rechargeable automatic cleaner that will self-beach when the battery runs out.

Specifications

Operation instruction

Precautions
Put into or lift out of the pool with the cleaner bottom towards the wall to avoid any possible scratches to the pool.

Please ensure that the top cover of the cleaner is tightly assembled to its chassis.

Power off the cleaner after use.
Grab the handle with a telescopic pole and the included hook to lift it out of the pool.
Hold the cleaner on the water surface for 10-15 seconds until it empties before removing from the pool.

Note: Do not touch the wall to avoid scratching the wall or damaging the cleaner when putting into the pool or lifting out of the pool.

Quick operation
Plug in the cleaner using the supplied adapter and charging line to charge the battery.

Note: When charging, it is strictly forbidden to leave the pool robot upsidedown to prevent the swing plate from being crushed.

• Power off the cleaner before charging.
• Clean the charging port before charging.
• Red charging indicator indicates the battery is charging.
• Green charging indicator indicates charging is finished. A full charge always takes 6-8 hours. The battery is not fully charged until after 6-8 hours even though the charging indicator turns green.

Put the cleaner into water and let it stand vertically under the water for 5-6 seconds to dischargethe air inside it. Press the switch to power on the cleaner. and lower the pool robot horizontally to the pool floor.
The cleaner will stop running after completing the working cycle. The handle can be hooked by a hook with a lengthened connecting rod, and the cleaner is pulled to the edge of the pool.

Power-off operation
A sound signal comes when lifting the pool robot out of the pool. Press theswitch to OFF and the cleaner will be shut down. Always clean the filter tray after use.

Functions and adjustment of wheels
There are 4 wheels on the cleaner, of which the left and right wheels are fixed. The front and back wheels can be selectively adjusted according to different conditions so as to adjust the running path of the cleaner.

Setting wheel angle and running path

Groove for wheel limit pile: A, B, C are printed on the groove of the wheel limit pile of the bottom. Wheel limit piles will be installed by default on C (left) and A (right).

As shown in the figure, push the wheel buckle, pull down the wheel components, and remove them. Then reinstall the limit pile into chassis to realize the different running paths
Three settings for wheels are recommended

Setting 1
Default, setting: B-C, for most of pools

Setting 2
C-A, when the turning angle is too large

Setting 3
C-C, when the length and width of the swimming pool are large (6m x 6m)

Setting 4
B-A, for round pools

Note: These are the recommended settings. Different settings may work better for your pool.

Cleaning the filter tray
Open the cleaner by the clips.

Trouble shooting

Sound signal information

Winter storage

During the winter season when the outside temperatures fall below 10°C Frisbee Pool Robot should be removed to prevent damage from freezing water. Store it inside in a dry and frost free location.
Note that the battery must be charged every 3 months to avoid capacity reduction. Otherwise, the guarantee will be void.

Packing list

Exploded view

Warranty

This robot is for private use only. If the machine is used commercially, the warranty time is 90 days.
The warranty period is according to the national laws regarding consumer purchase. The warranty period applies from the date of purchase on your purchase receipt. The receipt must be presented at service calls during the warranty period. It is therefore important that you save your sales receipt. The manufacturer guarantees safe operation and product liability based on the following specific conditions:

• Installation and use in accordance with the manual’s instructions.
• Use only original spare parts

The warranty does not cover normal wear and tear, scratches, abrasions or cosmetic damage. More specifically, the warranty does not cover damage caused if:

• Improper use or handling, including frost damages
• Fall or shock
• Repairs, alterations or etc. performed by anyone other than Swim & Fun
• Improper storing in extremely high or low temperatures, including frost

In the event of guarantee claims please contact your dealer. When returning a defective product, it must be packed in such a way that it is not damaged during transport. It is your responsibility that the product arrives safely. You must state your name, address, phone number and preferably your e-mail address. If the product are to be returned to you! Always remember to state what is wrong with your product.

Responsible Disposal

This symbol indicates that this product should not be disposed of with general household waste. This applies throughout the entire EU. In order to prevent any harm to the environment or health hazards caused by incorrect waste disposal, the product must be handed in for recycling so that the material can be disposed of in a responsible manner. When recycling your product, take it to your local collection facility or contact the place of purchase. They will ensure that the product is disposed of in an environmentally sound manner.

MV-1961-10-2022 . swim-fun.com © All rights reserved Swim & Fun A/S

Customer service:

swim-fun.com/support
Danmark +45 7022 6856
Sverige +46 771 188819

© All rights reserved Swim & Fun A/S 2022 Swim & Fun A/S
Ledreborg Allé 128 K, DK-4000 Roskilde info@swim-fun.com .
www.swim-fun.com

References

• Gifts for Him & Gifts for Her | Toys, Gifts & Clothing | Fun.com
• Pools, water care, and pool accessories
• Support
• Pools, water care, and pool accessories

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>