V-TAC VT-646 45W LED Panel Light Instruction Manual
- June 4, 2024
- V TAC
Table of Contents
V-TAC VT-646 45W LED Panel Light
TECHNICAL DATA
| Model | VT-646 |
|---|---|
| Watts | 45W |
| CRI | >80 |
| PF | >0.9 |
| Lumens | 5400LM (CONTAINING PRODUCT) |
| Beam Angle | 120° |
| Long Life | 30,000 Hours |
| Input Voltage | AC: 200-240V~, 50/60Hz |
| Dimension | 595x1195mm |
INTRODUCTION & WARRANTY
Thank you for selecting and buying the V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product. They aretrained and ready to serve you at your best. The warranty is valid for 5 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of the product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only.
WARNING!
- Please make sure to turn off the power before starting the installation.
- Installation should only be done by a certified electrician.
- The light source of this luminaire is not replaceable, when the light source reaches its end of life the whole luminaire should be replaced.
- If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
- Replaceable by a professional
- No protection against electric shock when replacing the light source.
- No protection against electric shock when replacing the separate control gear.
- For Indoor use only
Note: The panel works on DC 30-42V, please connect correctly with the conductor before connecting the conductor to the power supply main. This product contains a light source of energy efficiency class D
INSTALLATION DIAGRAM
INSTALLATION INSTRUCTIONS
- Make a hole into the ceiling.
- Fix the panel into the ceiling.
- Wire the DC cable of the panel to the driver and then wire the AC source cable to the power supply.
- Turn on the switch, test the fixture light on.
Steps to Remove the Light source for Verification
STEPS:
- Unscrew the back side of the panel
- Carefully remove the plate
- Use electric soldering iron to solder loose the “+ -“ lead wire like in the diagram
- Use a knife to remove the light source board from the frame for SLR Testing
IN CASE OF ANY QUERY/ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT: SUPPORT@V-TAC.EU FOR MORE PRODUCTS RANGE, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST DEALERS. V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>