LIGHTHOUSE Step Units for Liner Swimming Pool Installation Guide
- June 9, 2024
- LIGHTHOUSE
Table of Contents
Step Units for Liner Swimming
Pool
Installation Guide
Step Units for Liner Swimming Pool
Place the step unit flush with two edges of the pool wall in the corner that
you wish to have access to the pool.
Bead the wall edges of the step with the supplied CT1 to seal the gap between
the edge of the step and the wall.
The HeatForm steps are simply installed on the floor of the pool shell prior
to installing the pool liner.
Suitable for installation in conjunction with both onsite lining and pre- tailored bag lining systems, the HeatForm steps are an easy and quick solution to adding a touch of elegance to any liner pool.
Please note: If there is any chance of ground water ingress into the pool
shell it is recommended to install a vent kit through the wall. This is to
allow any trapped air to be released and avoid any damage to the pool lining.
See the example illustration of the vent system installation.
The Specialist Pool Distributor
01752 253525
www.heatform.co.uk
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>