RENAC 4G Stick Module User Manual

RENAC 4G Stick Module

Technical Data

Product Usage Instructions

1. Connect the 4G-G1 module to a power source with DC voltage between 5V and 12V.
2. Install a SIM card in the module.
3. Connect the antenna to the module.
4. The module will automatically connect to the network and establish a remote communication interface.
5. The module can now be used for remote data communication.

Installation instructions

Connecting Inverter
Pull out the 4G PCBA from the enclosure as below figure 1 , and insert the SIM card into SIM slot, then plug in the 4G enclosure.Plug the 4G-G1 module into the COM port of the inverter.

Download mobile APP
There are two ways to download Renac SEC:

• a. Download and install mobile app by scanning the QR code below.
• b. Download from Apple Store / Google Play.

Device Registration

1. Open the APP, fill out requirement information to create a new account, then click “Submit”.
2. Add the power station page, fill in the corresponding information, click [Add station] at the bottom to add a new power station (If you do not need to associate the installer account, the “installer” item can be ignored. with red is required *).
3. Click “+” and scan the QR code (inverter serial number) on the device label to add a device.
4. After adding the power station, back to home page, and the newly added power station will be shown in the station list.
5. On the home page, click “Statistics” to enter into the equipment list.
6. After the device is successfully added, wait for 5 minutes,while the inverter status is green, means that the 4G monitoring is successful.

Indicator Description

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>