Kuzco Lighting PD53305 Ceiling LED Pendant Instruction Manual
- June 9, 2024
- Kuzco Lighting
Table of Contents
Kuzco Lighting PD53305 Ceiling LED Pendant
Product Information: Ceiling LED Pendant PD53305
The Ceiling LED Pendant PD53305 is a modern and stylish lighting fixture that can be installed in any living space. It comes with a glass diffuser that provides even illumination, and a canopy that can be adjusted to the desired length. The fixture is easy to install and comes with all the necessary hardware.
Technical Support
If you have any questions or concerns regarding the installation or use of this product, please contact our technical support team at 1-855-855-8926.
Installation Instructions
- Remove the fixture from its original packaging and remove the fixture mounting plate (1c) from within the hardware package. Attach the fixture mounting plate (1c) to the electrical junction box (1a) on the ceiling using the two screws (1e) provided in the hardware package.
- Attach the fixture to the mounting plate, which is attached to the electrical junction box on the ceiling. First attach all wiring (1b) with the provided marrets (white to white N, black to black L, ground to ground G). Push the screws (1d) through the holes in the back of the canopy so they are poking through the canopy (2a). Once this is complete you can screw on the decorative nuts (2b) until the canopy (2a) is secured to the ceiling.
- Select the desired length you wish the pendant to hang. To shorten or lengthen the fixture push up on the canopy nipples (2c) and push/pull the cable, release to secure.
- With the canopy secure, connect the glass diffuser (3c) to the fixture chassis (3a) using set screws (3b).
- You have now completed the installation of your fixture, please enjoy.
For any additional information or questions, please refer to the product manual or contact our technical support team.
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- All Kuzco LED fixtures come with pre-wired LED module(s).
- Unless instructed to do so, please do not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage.
- For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
Technical Support: 1-855-855-8926
19054 28th Avenue Surrey,
BC Canada V3Z 6M3
T: 604 538 7162
TF: 1-855 85
KUZCO
F: 604 538 7196
W: kuzcolighting.com
20181127