HYPERX Pulsefire Haste 2 Gaming Mouse User Guide
- June 9, 2024
- HYPERX
Table of Contents
HYPERX Pulsefire Haste 2 Gaming Mouse
Overview
Left click button
Right click button
Mouse wheel
DPI button
Forward button
Back button
Optical gaming sensor
Grip tape
Mouse skates
Installation
Connect the USB connector to the computer.
DPI Presets
There are 4 default DPI presets: 400 DPI (red) | 800 DPI (blue) | 1600 DPI (yellow) | 3200 DPI (green)
Polling Rate
Switch between 1000Hz (default) and 8000Hz polling rate
- Hold down the DPI Button, while connecting the mouse to a computer
- Continue holding DPI Button for 5s. The LED will blink Red (1000Hz) or Blue (8000Hz)
HyperX NGENUITY Software
To customize lighting, DPI, macro settings, and more, download HyperX NGENUITY software at hyperx.gg/ngenuity
Questions or Setup Issues
Contact the HyperX support team or see user manual at hyperx.gg/support
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, according to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment of and on, the user is encouraged to try
correct the interference by one or more of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the
instruction manual.
Warning:
A shielded-type power cord is required in order to meet FCC emission limits
and also to prevent interference to the nearby radio and television reception.
It is essential that only the supplied power cord be used. Use only shielded
cables to connect I/O devices to this equipment.
CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void your authority to operate the equipment.
India RoHS Statement
This product, as well as its related consumables and spares, complies with the reduction in hazardous substances provisions of the “India E-waste (Management and Handling) Rule 2016.” It does not contain lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated diphenyl ethers in concentrations exceeding 0.1 weight % and 0.01 weight % for cadmium, except for where allowed pursuant to the exemptions set in Schedule 2 of the Rule.
©Copyright 2022 HyperX and the HyperX logo are registered trademarks or trademarks of HP Inc. in the U.S. and/or other countries. All registered trademarks and trademarks are property of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>