UGREEN LP586 Selfie Stick Tripod Instructions
- June 4, 2024
- UGREEN
Table of Contents
UGREEN LP586 Selfie Stick Tripod Instructions
1.BLUETOOTH PAIRING
Power on after long pressing the power button for 3 seconds, then turn on the phone bluetooth to enter search condition, and click “Dispho” in the searched equipment. Green light of the remote control will be o after connected.
2.USE TRIPOD
This product comes with a tripod. Open the selfie holder from the bottom and fix it on a steady horizontal plane.
3.FIX THE PHONE
Rotate the phone holder till you can pull open the holder handle and fix the phone securely on the holder.
4.UNIVERSAL COLD SHOE PORT (OPTIONAL)
The cold shoe port can be connected to the adaptable live broadcast accessories to expand the multifunctional usage scenarios.
5.REPLACE THE ACCESSORIES
Take the bracket o and put it Screw installation
6.UNIVERSAL 1/4 BRITISH SCREW ROD
The 1/4 British Screw Rod can be connected to the adaptable live broadcast accessories to expand the multi-functional usage scenarios.
Battery replace of the remote control
Remove rear cover of remote controller and replace button battery (CR1632).
*On first use, remove rear cover of remote controller and take insulator out of battery chamber.
Warnings
- Watch your hands during use.
- The product is not designed for children under 14 years old. Do not swallow it.
- Do not dismantle or modify the product.
- Do not store the product in a humid environment.
- Keep the product away from heat sources.
- Do not expose the product to water or other liquids in case of damage.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Information The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
ISED Statement
This device complies with Industry Canada license exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device. The
digital apparatus complies with Canadian CAN ICES3 (B)/NMB3(B).
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
RF Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used installed and operated with minimum distance 0mm between the radiator and your body.