sudio A2 True Wireless Earbuds with Charging Case Owner’s Manual
- June 9, 2024
- Sudio
Table of Contents
sudio A2 True Wireless Earbuds with Charging Case
WHAT’S IN THE BOX
- A2
- Charging cable
- Eartip holder
- Warnings
- Owners manual
HOW TO USE
- Remove stickers
- Place earbuds in case
- Remove from case and connect the device
- 1 tap
- Tap 2x left
- Tap 2x right
- Tap 3x right
- Tap 3x left
- Turn ANC on/off: Hold any side 2 sec.
- Accept calls: I tap
- Hang up or reject calls: Hold button 2 seconds
- Hold the button 6 seconds to turn off the earphones
- Hold L&R button 8
- seconds to reset
CHANGING
- Charge with USB-C. White light shows the charging level.
BATTERY PERCENTAGE
- LED blinks when low battery (0-25%), and white light between
POWER BUTTON
- Place earphones in charging case to turn off. Remove from case to turn on.
Studio Help Center
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: ((12)) interference that may cause undesired operation. Warning Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: his equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet the general RF exposure requirements.
The device can be used in portable exposure conditions without restriction.