chicco 05079540780000 Baby Walker Walky Talkie User Manual
- June 9, 2024
- chicco
Table of Contents
05079540780000 Baby Walker Walky Talkie
User Manual
05079540780000 Baby Walker Walky Talkie
|
---|---
WALKY TALKY
IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.
WARNING: BEFORE USE, REMOVE ANDDISPOSE OF ALL PLASTIC BAGS ANDPACKAGING
MATERIALS AND KEEPTHEM OUT OF REACH OF CHILDREN.
WARNINGS
WARNING: Nev leave the child unattended.
- WARNING: Before using for the first time, check that the product and all its components won’t show signs of damage caused by transportation. Check the product regularly for signs of wear and damage. Keep all damaged parts out of children’s reach.
- WARNING: This product must only be assembled by an adult. Follow the instructions below to guarantee correct assembly of all the components.
- WARNING: The child will be able to reach further and move rapidly when in the baby walking frame.
- WARNING: Prevent access to stairs, steps and uneven surfaces. Do not use on sloped or unstable floors, near swimming pools or other water sources.
- WARNING: Guard all fires, heating and cooking appliances.
- WARNING: Remove hot liquids, electrical cables and other potential hazards from reach.
- WARNING: Prevent collisions with glass in doors, windows and furniture.
- WARNING: Do not use the product if some of its parts are damaged, torn or missing.
- WARNING: This baby walker should be used only for short periods of time (e.g., 20 min).
- WARNING: This product is intended only for a child who can sit up by itself and until it is able to walk by itself or weighs more than 12 kg.
- WARNING: Do not use replacement parts other than those approved by the manufacturer or distributor.
- WARNING: Before use, ensure that all the safety devices are fitted and working correctly.
- WARNING: Keep your child away from all moving parts whilst you adjust the baby walker.
- The baby walker is not suitable for children over 85 cm in height.
- To avoid all risks of strangulation, never give children objects with cords or strings attached, or leave them near such objects. Watch out for curtain and blind cords, etc.
- The baby walker is not designed to be used when feeding a child; do not use when feeding to avoid damages or malfunctions of electrical parts due to contact with food.
- Keep all plastic bags and small toys away from children to prevent the risk of suffocation.
- Never leave the product exposed to bad weather or direct sunlight. If the baby walker is left exposed to direct sunlight for a long time, allow it to cool down before let your child use it.
- Prolonged exposure to sunlight can cause fading in fabric and materials colours.
- Do not use this product with temperature below 5 °C or on slippery and/or icy surfaces.
- Do not use this product as a sledge or raft in the water.
- Check the baby walker regularly for signs of wear and damage.
- Always check that the stoppers are fitted correctly and show no sign of damage or tear.
- Do not allow other children to climb onto or play without the supervision of an adult near the baby walker.
- When not in use, store the baby walker in a suitable place, away from contact with all weather conditions and out of the reach of children.
- Pay attention when using on flooring made of delicate materials as the wheels may damage it.
CLEANING & MAINTENANCE
The cleaning and maintenance operations must only be carried out by an adult.
Clean the fabric and plastic parts including the stopper with a damp cloth.
Do not use solvents or abrasive products for cleaning.
Dry the metal parts to prevent the formation of rust.
PADDED SEAT COMPOSITION:
100% polyester outer layer, 100% polyurethane inner layer
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
COMPONENTS/PARTS
A) Structure of the baby walker
B) Upholstered padded seat
C) Rigid spoiler
D) 2 front swivel wheels
E) 2 rear fixed wheels
F) 6 stoppers
G) Electronic toy panel
H) Padded seat fixing bands
I) Bar support
FIRST ASSEMBLY OF THE BABY WALKER
-
Turn over the structure (A) of the baby walker. Attach the front wheels (D) in their slots as shown in figure
-
Make sure the wheel pin has come to its limit. 2. Attach the rear wheels (E) in their slots as shown in figure
-
Make sure the pin has come to its limit: a click will be heard and the fastening pin will appear from the hole.
-
Secure all the stoppers (F) in their slots as shown in figure 3.Make sure that the pins of all the stoppers have come to their limit.
-
Bring the baby walker to position for use by turning the wheels to the floor (levelled and horizontal); slowly lift the upper part of the structure as shown in figure 4, by pulling it upwards until it clicks into place in the desired position.
WARNING: Before putting the child in the baby walker make sure the knob located below the upper part of the structure has reached its engagement position: a click will be heard to indicate it is locked (fig. 4a). Then push down the structure to ensure the proper engagement. -
Insert the front tabs of the rigid spoiler (C) into the slots cut on the upper part of the structure (A) and push down on the back until a click is heard locking them (fig. 5). WARNING: Once the spoiler is inserted it’s no longer possible to pull it out. Do not try to remove it with a screwdriver or other tool.
-
Insert the padded seat plastic rings (B) in the slots formed along the top edge of the baby walker (fig. 6) and make surrey are properly locked in the shown position (fig. 7-8).
-
The electronic toy panel with sounds and lights can be placed on the upper part of the structure with a simple pressure (fig. 9); It does not require any type of fixing. Batteries not included; the toy has two holes located under it to allow to fix the toy on different parts of the baby walker through the included fixing bands (fig. 10). WARNING: To prevent the risk of suffocation, the electronic toy panel must be fixed to other parts using only items included (fixing bands), do not add laces. WARNING: When the toy is not fixed to other parts keep the bands out of reach of children; do not place the toy on the baby walker with the fixing bands mounted. WARNING: The bar support must be installed by the parent before allowing the baby to use the walker.
-
The bar support (I) with movable toys is installed by inserting side intersections in their seats on the top of the structure, pushing down until they click (fig. 11-12).
HEIGHT REGULATION OF THE BABY WALKER
WARNING: When opening, closing or regulating the baby walker, make sure that your child is at a safe distance. -
To open the baby walker slowly lift the upper part of the structure by pulling it upwards and supporting it from below until it clicks into the desired position (fig. 4).
-
To adjust the seat height, after taking the child from the baby walker, push the upper part of the structure upwards until it clicks into its locked position. To lower the height move the knob located below the upper part of the structure and turn it counter-clockwise (fig. 13), push the knob up, accompany the upper part to the desired position (fig. 14). Upon release of the pin, the structure is automatically locked. The height can be adjusted to three different positions.
WARNING: Before putting the child in the baby walker, make sure that the knob is properly locked in place as shown in figure 15. -
To close the baby walker, turn the knob located under the top part counter-clockwise and push it upwards. Then lower the top part until completely closed (fig. 16). WARNING: Do not close the baby walker with the child inside.
BAR SUPPORT
To properly use the bar support, starting from the rest position (resting on
the upper part of the structure), do the following:
– Pull the bar support out of the baby walker in the direction of the arrow at
the end of the intersections until it stops; grab the bar in the middle part
(fig. 17);
– Then rotate the bar support upwards, until it clicks locked (fig. 18). To
take down the bar support and to bring it back in its original position,
follow these steps:
– Pull the bar support out of the baby walker in the direction of the arrow at
the end of the intersections until it stop scolding it in the middle part
(fig. 19);
– Then turn the bar support downwards (fig. 20), bringing it back to the rest
position (fig. 21).
WARNING: Keep your child away from all moving par whilst you adjust the
baby walker.
WARNING: Do not move or lift the baby walker grabbing it at the bar
support or at features on it.
WARNING: Do not lean on the bar support.
ELECTRONIC TOY PANEL
WARNING: Regularly inspect the toy for signs of wear and any damage. In
case any part would be damaged or not operating correctly, do not use the
product and keep it out of reach of children. Do not use it and/or try to
repair it, but contact qualified personnel only.
CARE AND MAINTENANCE OF THE ELECTRONIC TOY PANEL
- WARNING: Clean the toy using a soft dry cloth to avoid damaging the electrical circuit.
- WARNING: Protect the toy from heat, dust, sand and water.
- WARNING: The baby walker is not designed to be used when feeding a child; do not use when feeding to avoid damages or malfunctions of electrical parts due to contact with food.
- WARNING: This product must only be assembled by an adult.
REMOVAL AND/OR REPLACEMENT OF BATTERIES FROM ELECTRONIC TOY PANEL
WARNING:
- This toy requires 2 1.5V AA alkaline batteries (not included).
- Batteries must only be fitted by an adult.
- To fit and/or replace the batteries: Loosen the screw on the battery compartment cover with a screwdriver and open the cover, remove the spent batteries, fit the new ones, making sure that they have been fitted with the correct polarity as shown in the battery compartment, fit the cover again and tighten the screw.
- Always keep batteries and tools out of the reach of children.
- Do not leave the product outside under the rain; water infiltrations will damage the electronic circuit.
- Always remove discharged batteries from the product to avoid any possible liquid leaks that may damage it.
- Always remove the batteries if the product will not be used for a long period of time.
- Only use alkaline batteries of the same type or equivalent to the type recommended for a correct product functioning.
- Never mix new and old or different types of batteries.
- Do not throw dead batteries in fire or leave them in the environment; they must be disposed of through waste sorting.
- Do not short-circuit the power terminals.
- Do not try to recharge non-rechargeable batteries: they may explode.
- The use of rechargeable batteries is not recommended as they may reduce the toy’s operability.
- If the batteries are leaking liquid, replace them immediately, making sure to clean the battery compartment; thoroughly wash your hands in the case of contact with the liquid.
- If rechargeable batteries are used, remove them from the toy before recharging and recharge them only under adult supervision.
- Rechargeable batteries must be charged only under adult supervision.
- Rechargeable batteries must be removed from the product during recharging.
- Never use new and old batteries together as this will allow the product not to function properly.
- Remove batteries from the product before dispose it.
THIS PRODUCT COMPLIES WITH THE DIRECTIVE 2012/19/EU.
The crossed bin symbol on the appliance indicates that the product, at the
end of its life, must be disposed of separately from domes- tic waste, either
by taking it to a separate waste disposal site for electric and electronic
appliances or by returning it to your dealer when you buy another similar
appliance. The user is responsible for taking the appliance to a special waste
disposal site at the end of its life. If the disused appliance is collected
correctly as separate waste, it can be recycled, treated and disposed of
ecologically; this avoids a negative impact on both the environment and
health, and contributes towards the recycling of the product’s materials. For
further information regarding the waste disposal services available, contact
your local waste disposal agency or the shop where you bought the appliance.
Made in China
WARRANTY
The product is guaranteed against any conformity defect in normal
conditions of use as provided for by the instructions for use. The warranty
shall not therefore apply in the case of damages caused by improper use, wear
or accidental events. For the duration of warranty on conformity defects
please refer to the specific provisions of national laws applicable in the
country of purchase, where provided.
ARTSANA UK Ltd.
2nd Floor
1 Imperial Place
Maxwell Road
Borehamwood
Hertfordshire – WD6 1JN
0208 953 6627 (office hours)
www.CHICCO.co.uk| ARTSANA S.p.A. -1 – 22070
Grandate (CO) – Italy
Tel. (+39) 800 188 898
– Fax (+39) 031 382 400
www.chicco.com
---|---
References
- Site Officiel Chicco Belgique | Chicco.be
- Ihre Vetrauensmarke für Baby- & Kinderartikel | Alles für Ihr Baby
- Official Corporate Chicco website
- Tienda para bebés y recién nacidos | Chicco Argentina
- Site Oficial Chicco Brasil
- Chicco México
- Ihre Vetrauensmarke für Baby- & Kinderartikel | Alles für Ihr Baby
- Productos Bebés y Niños | Chicco.es
- Site Officiel Chicco France | Chicco.fr
- Best baby products in India | Infant care products online Chicco India
- Chicco Portugal - Puericultura, Roupa e Brinquedos
- Официальный сайт Chicco Россия
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>