GLOMEX V9112AGCU DVB-T2 TV Antennas Range Owner’s Manual

GLOMEX V9112AGCU DVB-T2 TV Antennas Range Owner’s Manual

www.glomex.it
www.glomex.us

SAILBOAT ANTENNA INSTALLATION LOCATION

V9173TV Stainless steel masthead mount bracket for V9112ACCU/DAB
V9123 Stainless steel masthead mount bracket for V9125ACCU/DAB

POWER BOAT ANTENNA INSTALLATION LOCATION

Installation Notes.
• Keep clear the antenna from any obstructions.

.

COAXIAL CABLE INSTALLATION

Installation Notes:

• Do NOT bend the coax cable in a radius less than 90º
• Use screw-up wire ties to secure to bulkheads
• Do NOT Staple coax to bulkhead.

TWIST-ON F CONNECTOR INSTAUATIO INSTRUCTIONS

COAX SPLICING

Splicing Installation Notes: It is always better to run new coax cable at the proper length, as the 20 mis supplied with the antenna, without splices.

This will provide the best performance from your Glomax TV antenna.

The coax cable should never be spliced wire-wire.

when splicing with connectors, use only 75 Ohm connectors only..

Remember each splice represents again l0DB of 1.5 DB or more

“F” CONNECTION INSTALLATION

V9173 TV MASTHEAD MOUNT GASKET INSTALLATION

Installation Notes:

A tool to connect the “F” connector is included in your pack.

1 Slip tool over coax with nut and toward the connector. Make sure the coax cable is fed through heat the mount before connection is made.

2. slide the tool over the connector.

3. Turn the connector to attach it to the receptacle inside the antenna base.

4. Remove the tool and mount the antenna on the boat mount.

AMPLIFIER INSTALLATION 50023/14 FOR NASHIRA AGC DAB AND TALITHA AGC DAB

NASHIRA AGC DAB, AND TALITHA AGC DAB FEATURES AND OPERATION

SHARK FIN AND DAB WHIP INSTALLATION FOR NASHIRA  AGC AND TALITHA AGC DAB

Thanks to vertical inside the “shark fin”, Nashira and Talitha can receive TV signals vertically polarized, put the O ring in the bole on the redone (fig 1 and fig 2), screw the “shark fin” in the hole (fig 3) elsewise and on perpendicular position (fig 4). screw in (about 7 turnal) (fig 5) until it is well tightened by the rib in the relied (fig 6), Screw the DAB whip in the hole on the “shark fin” (fig 7 and fig 8) clockwise and in perpendicular position. Screw it until it is well tightened (fig 9).

Installation Trouble Shooting Guide for TV antenna Nashira AGC DAB and

Talitha AGC DAB

Where I best to install my new Glomex Antema?

Your antenna should be mounted free and clear of any obstruction and as high as possible.

If I mount it on a radar arch, will the array interiors with the reception?

Yes and on the other way around. Make sure that the Glomex dome is either above or bellow the radar array and never on the same “plane” as the array.

What cable should I use?

It is important to use only FD6 Twin Screen low loss cable. We recommend that you use only a DSS quality cable.

How can I tell if a cable is either low loss or not?

A high quality low loss cable will have a white foam canter insulator where a lower grade of cable will be opaque and sold.

What type of connector should I use?

Use only “F” gold connectors for TV wire 6.8 mm or a wire with the same diameter of the used one.

How do I get the “F” connector into the base of the antenna?

Included in your Glomex Marine TV Antenna package is a flack plastic-toot, this tool is designed to slide over the coax and grip the connectors it maybe twisted on.

Where should the amplifier be installed?

The amplifier should be installed in a dry well ventilated place. The automatic gain control amplifier can be placed in a hidden location inside the boat ant it does not need a manual adjustment.

What power supply will need to power my amplifier?

You can use either a12 Vdc or you can purchase the optional V9117 220 Vac power adapter

How can I connect a DAB radio to my Glomex TV antenna?

This Glomax TV antenna is supplied with 1m 0.3) pro-wired DAB cable with F male and SMB female connectors [code: DA390/1) that can be used to connect the AGC amplifier with a DAB radio with SMB male input

Is it possible to connect a FM radio to my Glomex TV antenna?

Yes, by installing an optional FM cable (code: V9148)

Can the Glomex TV antenna be damaged by lighting?

No because of its unique design and no active parts in the dome, so it won’t attracted it. Anyway, if it fall down very close to the boat it might damage it.

In a sailing boat, is the masthead the only place where I can mount the antenna!

It is the best place to install it. Make sure you use a Glomex V9173TV masthead bracket for your installation for V911246 CLVDAB or a Glomex V9123 masthead bracket for your installation for V912546CW/DAB

I have installed the amenna and I don’t get the local station. What should I do?

First, gather a list of the broadcasting station that you should receive in that area. Next, turn on the TV (and turn an the Digital Terrestrial Decoder if it’s not integrated on the TVI. Then, go to the menu, select signal research.

Why do NOT I have to adjust the gain control?

50023/14 amplifier automatically adjust the signal gain. So, it makes your life easier and more comfortable. You have many different factors affecting your reception. If you are very close to a broadcast tower you will needless gain. The further you are from the tower, the more gain you will need. In the marina, with a lot of sailboats and larger yachts, you will have a lot of signal reflections and you will have the ability to adjust the gain accordingly. With Nashira AGC DAB and Taltha ABC DAB you do not need to make anything, just relax and watching TV.

How do I tell if I have installed a connectar properly?

Make sure that the central conductor is long enough to insert into the connector on the TV or amplifier. Also check and make sure there is no shield touching the center connectar in the cable. If there is a “short” you will see a see a strand touching the center wire.

I have a sailboat but my coax is not long enough to reach the point that I want to install my amplifier.

You may connect an extension to the coax by using an F 75-Ohm connector, For every connection you put on line. you lose gain and thus degrade your reception. This holds true even with the proper connectors. We strongly recommend that you run a new coux that is the proper length. It may be more work but well worth it.

I have a large number of TV and pictures are freezed.

If you have more than 2 TV you should be using an inline amplifier to boast the signal through the boat (code: 50022/101

Can I receive FULL HD and DVB-T2 TV signals?

Yes, using a suitable TV

WEEE

ENGLISH: Environment

Do not throw the appliance away with the normal household waste at the end of its life, but hand it in at an official collection point for recycling By doing this you will help to preserve the environment.

LIFETIME WARRANTY

Glomex warrants its products to be free of defects in materials and workmanship for as long the products remains the property of the original purchaser.

Glomex’s obligation under this warranty is limited to repair or replace defective products.

No material will be repair or replace defective products.

No material will be repaired or replaced without written authorization from Glomex or it’s assigned representatives.

Repair or replacement will be made only after an examination indicates defective material or workmanship at time of manufacture.

Glomex is in no event liable for consequential damages, installation costs or costs of any nature incurred as a result of the use of the products manufactured by Glomex, whether used in accordance with instruction or not. All shipping costs on returned materials are responsibility of the purchaser Glomex is not liable for repair or replacement of any products damaged by lighting or any other natural phenomenon or incorrect installation Including reverse polarity connections.

This warranty is in lieu of all others either expressed or implied. Proof of purchase is required.

FCC STATEMENT

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

SIMPLIFIED EU DECLARATION OF CONFORMITY

The manufacturer Glomex declares that the radio equipment type 50023/14 is in compliance with European Directive 2014/53/EU. The full text of the EU Declaration is available at the following internet address: http://www.glomex.it/leisure/eng/certifications.php

Glomex s.r.l – Via Faentina 165/G-48124 Ravenna, Italy

Ph. +39 0544 500377 – Fax +39 0544 500420 – sales@glomex.it

www.glomex.it

Glomex Marine Antennas USA Ph. 305-497-2681

www.glomex.us – info@glomex.us

Read More About This Manual & Download PDF:

References

• LEISURE TV/COMMUNICATION Archivi - Glomex

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>