GravaStar SIRIUS P5 True Wireless Earbuds User Manual

SIRIUS P5 True Wireless Earbuds

Product Information

• Model: Sirius P5
• Dynamic Driver: 12mm
• Noise Canceling: Environment Noise Canceling (ENC)
• Battery Type: Polymer lithium-ion battery
• Earbuds Charging Time: 1.5 hours
• Single Earbuds Battery Capacity: 45 mAh
• Single Earbuds Weight: 5g
• Charging Case Battery Capacity: 500 mAh
• Charging Case Charging Time: 2 hours
• Input: 5V–350mA
• Output: 5V–150mA
• Playtime: Up to 8 hours of listening time with full charge (50% volume)
• Standby time: Around 80 hours
• Bluetooth: V5.2
• Bluetooth Protocol: A2DP, AVRCP, HFP
• Decoding Format: SBC/AAC/APTX
• Bluetooth Distance: >10m
• Sensitivity: 105dB+/- 3dB
• Frequency response range: 20Hz – 20KHz

Product Usage Instructions

Wearing Earbuds

1. Put the earbuds downward gently into the ear canal.
2. Shake your head lightly and the earbuds will stay still.
3. When you wear the earbuds correctly, the LOGO should face up.

Charging

1. The first time you use, please take out earbuds, remove the isolation film on the earbuds, get the charging case and earbuds fully charged first.
2. Low battery reminder: when the battery is lower than 10%, you will hear the cue tone “Not enough energy” in every 5 minutes, and see the red light flashes (2 times / s ).
3. Charging: red breathing light will be on. Fully charged: the indicator light will be off.
4. Remove the isolation film.

Bluetooth Connection

To connect Sirius P5 with your phone or Bluetooth devices, follow the steps below:

1. Put Sirius P5 into the case, and screw them tight together.
2. Tear off the protective film on the earbuds, and put earbuds back into the charging case and close the lid, then open the lid to activate the earbuds and turn them on.
3. Turn on Bluetooth on your phone, find GravaStar Sirius P5 on the list, click and connect.
4. Once Bluetooth connects successfully, you will hear the cue tone “Bluetooth connected”, when you disconnect the Bluetooth, you will hear “Bluetooth disconnected”.

Controls

• Press 3s to turn it on
• Double-press on MFB button
• Left Right
• Press 3s to turn it on

Lights

• Indicator light
• Reset / RGB Light Switch
• Single press to change the light color, double press to turn the light off
• Indicator light: Charging: The light will turn red when the battery is less than 30%. When the battery is more than 30%, the light will turn to green color with breathing effect. Fully charged: The light will be green and always on. Charging case battery indicator: Open or close the lid / Take out or put back earbuds. Red: Battery is less than 30%. Green: Battery is more than 30%.
• Reset: With earbuds in the charging case and keep the lid open, press 5s on the button of the charging case to reset.

Product Info

Wearing Earbuds
Put the earbuds downward gently into the ear canal, shake your head lightly and the earbuds will stay still. When you wear the earbuds correctly, the LOGO should face up).

Charging
The first time you use, please take out earbuds, remove the isolation film on the earbuds, get the charging case and earbuds fully charged first.
Low battery reminder: when the battery is lower than 10%, you will hear the cue tone “Not enough energy” in every 5 minutes, and see the red light flashes (2 times / s ).

Tech Specs

• Model: Sirius P5
• Dynamic Driver: 12mm
• Noise Canceling: Environment Noise Canceling (ENC) Battery Type: Polymer lithium-ion battery
• Earbuds Charging Time: 1.5 hours
• Single Earbuds Battery Capacity: 45 mAh
• Single Earbuds Weight: 5g
• Charging Case Battery Capacity: 500 mAh
• Charging Case Charging Time: 2 hours
• Input: 5V–350mA
• Output: 5V–150mA
• Playtime: Up to 8 hours of listening time with full charge (50% volume)
• Standby time: Around 80 hours
• Bluetooth: V5.2
• Bluetooth Protocol: A2DP, AVRCP, HFP
• Decoding Format: SBC/AAC/APTX
• Bluetooth Distance: >10m
• Sensitivity: 105dB+/- 3dB
• Frequency response range: 20Hz – 20KHz

Bluetooth Connection
To connect Sirius P5 with your phone or Bluetooth devices, follow steps 1-4.

1. Put Sirius P5 into the case, and screw them tight together.
2. Tear off the protective film on the earbuds, and put earbuds back into the charging case and close the lid, then open the lid to activate the earbuds and turn them on.
3. Turn on Bluetooth on your phone, find GravaStar Sirius P5 on the list, click and connect.
4. Once Bluetooth connects successfully, you will hear the cue tone Bluetooth connected, when you disconnect the Bluetooth, you will hear Bluetooth disconnected.

Controls

Lights

Single press to change the light color, double press to turn the light off Indicator light:

• Charging: The light will turn red when the battery is less than 30%. When the battery is more than 30%, the light will turn to green color with breathing effect
• Fully charged: The light will be green and always on

Charging case battery indicator: Open or close the lid / Take out or put back earbuds

• Red: Battery is less than 30%
• Green: Battery is more than 30%

Reset: With earbuds in the charging case and keep the lid open, press 5s on the button of the charging case to reset.

Case Installation

FAQs

Put the earbuds back to the charging case
Earbuds are not in charging| Dirty of the connecting parts on the charging case or earbuds| Make the connecting parts clean
Can’t find earbuds by Bluetooth| Earbuds are not visible for connecting| Follow the steps of Bluetooth connecting to make it visible to the devices.

Cautions
Warnings

1. Do not disassemble, repair or modify the headset for any reason, otherwise it may lead to fire or even complete damage to the product.
2. Do not place the device in an environment where the temperature is too low or too high (below 0°C or above 45°C).
3. When using the product indicator, please avoid the eyes of children or animals.
4. Do not use the product in thunderstorm weather, thunderstorms can cause the equipment to work abnormally and increase the risk of electric shock.
5. Do not use alcohol or other volatile liquids to wipe the product.
6. Do not contact the product with liquids.

Notes

1. Please read this instruction manual carefully before using the earbuds and keep it in a safe place.
2. When using the earbuds for the first time,  please fully charge the product first.
3. If the earbuds is not used for a long time (more than 2 weeks), please charge it.
4. Must choose the regular manufacturer and the national CCC certified charger.
5. Long time continuous use of earbuds is detrimental to hearing, please control use of time and volume reasonably.
6. The use of earbuds will reduce the perception of external sound, please do not use the earbuds in an environment that may threaten safety.

Connect To Two Devices

Supported Operating System:

Function:
Connect to two Bluetooth devices at the same time, real-time switch between the devices.

How to:

1. Turn on the Bluetooth of device A (e.g. iPhone) to search GravaStar Sirius P5 in the Bluetooth list, click to connect, after the earbuds connected successfully, disconnect it.
2. Turn on Bluetooth on device B (e.g. computer, Android phone) to search GravaStar Sirius P5 in the Bluetooth list, click to connect, after the earbuds connected, than you can turn on the Bluetotoh on device A and conenct it to Sirius P5. Now all set up, you have connected the Sirius P5 to 2 devices.

Warranty and Support

Warranty Period:
1 year since the day you buy the product

Warranty:

1. Within the warranty period, from the date of your receipt, for any failure caused by the quality of the product itself, the user should contact the seller with the proof of purchase to get support. You can enjoy the repair, or replacement service.
2. If any product damage or defect is not attributable to the product quality itself, it will not be covered by the warranty. The following situations are not covered by the warranty:
   • Failure or damage caused by natural disasters, earthquakes, lightning strikes, abnormal voltages, and environmental factors.
   • Disassemble, modify or replace non-original parts by yourself or by a manufacturer who is not authorized by the original manufacturer to repair.
   • Failure to operate in accordance with the manual or damage caused by improper use of the product, such as the product being immersed in water, corroded, dropped, squeezed or exposed to abnormal temperature and humidity.
     Please contact service@gravastar.com for support.

FCC regulatory conformance：
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television  reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

www.gravastar.com
Customer Support: service@gravastar.com

Facebook: @GRAVASTAR1/
Instagram: @GRAVASTAR_ZOEAO

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>