Q Play Honeycomb v2 LED Scooter User Manual

Q Play Honeycomb v2 LED Scooter

Assemble

User guidance

• Press the button the second time: The light goes on and off at a slow frequency
• Press the button the third time: The light goes on and off at a fast frequency
• Press the button the fourth time: The light goes off

Attention:
When folding the scooter ensure the front wheel is facing forward to close properly and keep fingers away from all movable parts.

WARNING!

Adult assembly is required!

WARNINGS!
Not suitable for children under 36 months. Small Parts. Choking Hazard. Protective equipment (helmet, gloves, wrist- guards, elbow, and knee pads) should be worn. Not to be used in traffic. Alt assembly required. Adult supervision is recommended.

• Max weight: 50 kg (1 10 lbs).

INSTRUCTIONS

Recommended Age: 5 years +
Skills are required to properly use the product and to avoid falls or collisions that could cause injury to the user or third parties. Use with caution and under adult supervision.

Before each use, ensure:

• All screws, nuts, bolts, and clamps are properly and securely fastened.
• The steering system is correctly adjusted and the connective components are firmly secured and not broken.
• The brake is in working order.
• The user is wearing closed shoes.

DO NOT:

• Use on wet, oily, sandy, dirty, icy, rough, or uneven surfaces. Use only on flat, clean, and level ground.
• Jump stairs, curbs or do other stunts.
• Use on roads, paths, or other places with motor vehicle traffic.
• Ride in the darkness.
• Use near pools or bodies of water.
• Ride at excessive speed or down steep hills.
• Make any modifications to the product.
• Touch the brake pad. It will become hot from continuous use.
• Leave the product outside overnight or under wet conditions.
• Allow several children to climb on the product. One child at a time only.
• Ride the product with one hand only.
• Make sharp turns, and/or place your weight on the handlebar. The scooter may go out of control, and cause the user to fall.

MAINTENANCE

Regularly check the general condition of the product, and contact the place of purchase if any parts need to be changed (rusted components, worn out wheels, etc…). Regular checks will increase the lifetime and enhance the safety of the product.

Ensure to:
Disassemble, clean, and lubricate the scooter every 6 months. Regularly check self-locking nuts and other self-locking fixings. They may lose their effectiveness after some time.

To remove the wheels:

• Unscrew the center bolts using a wrench/Allen key and remove the wheel.
• Replace with a new wheel or wheel bearing. Screw back in the bolt.
• Note: Going through water, oil or sand may damage the wheel bearings.

Cleaning

Use a damp cloth with mild soap to clean the product. DO NOT over-wet the cloth, use alcohol, industrial cleaners, or solvents as they might damage the product.

BATTERY ADVICE

1. Requires 4 x AAA batteries. Not Included.
2. Batteries should only be replaced by an adult.
3. Do not mix old and new batteries.
4. Do not mix alkaline, standard or rechargeable batteries.
5. Do not recharge non-rechargeable batteries.
6. Rechargeable batteries are only to be charged under adult supervision.
7. Rechargeable batteries are to be removed trom the product before being charged.
8. Ensure batteries are inserted with the correct polarity.
9. Exhausted batteries should always be removed.
10. The terminals should not be short-circuited.

Product Specifications

Designed in Germany, manufactured in P.R.C.Contact your local distributor.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>