SICHUAN WXCD Wireless Charging Base TPM module Instructions
- June 10, 2024
- SICHUAN
Table of Contents
SICHUAN WXCD Wireless Charging Base TPM module Instructions
Function description
Figure 1 shows the wireless charging base, which is used to charge the
TPM module.
Figure.1
Connection description
As shown in Figure 2, one end of the extension cable we provided is
connected to the red line of the wireless charging base, and the other end is
connected to the 12V power supply. The two lights on the handle of the
wireless charging stand blink for a few seconds and then stay on.
Figure.2
Use procedure
As shown in Figure 3, place the TPM on the wireless charging base. If
placed correctly, it will start charging and the light marked by the red box
will keep flashing as shown in Figure 4.
Figure.3
Figure.4
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>