Sichuan Coolux Technology V501 LED Projector User Manual

USER MANUAL
V1.0

FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any reference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.
  Increase the separation between the equipment and receiver.
  Connect the equipment into an outlet on a circuit different from that to which the receiver is
  connected.
  Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Important safety considerations

• The following safety instructions ensue the long service life of the projector to avoid fire or electric shock. Make sure to read them
  carefully and pay attention to all the following warnings.

• Do not install the projector in sites with improper ventilation.

• Do not install the projector in hot and humid sites.

• Do not block the ventilation holes(intake or exhaust).

• Do not install the projector in dust and smoke sites.

• Do not install the projector near the temperature and smoke transducer. It may cause a sensor failure.

• Do not install the projector in sites with the direct blowing of the warm and cool air-conditioned wind. Othawise may cause the project failure
  due to moisture condensation or temperature increment.

Pαckage Inclυde

FAQ:

1. MAC/ M。bile Phone C 。nnectlon
   ①Mac Book air:
   Needs an extra Mini Display Port to HD adapter(not included)
   ②Mac Book Pro:
   Needs an extra Type C to HD adapter（『10t Included)
   ③Android:
   Needs an extra Micro USB to HD/ Type C to HD adapter (not 1hcluded)
   ⑥iPhone:
   Needs an extra Lightning to HD adapter(not included)
   

2. Blurry Image
   ①Adjust keystone correction to make the image rectangular.
   ②Second, rotate the focus button to gain the best clarity.
   Effective Projection Distance: 1.2 M – 4.8 M

3. Mounting Hole
   The sector’s mounting holes a compatible with standard camera tripods and projector brackets with 1/4-inch mounting screws.

Product Function Structure Diagram
Note: The remote control must correspond to the Infrared or screen of the fuselage to be effective.

First Use

1. Power on/off
   ****

Connect the power cord to the projector, slide the lens cover to the right and the projector will start automatically. With the lens cover open, aim the remote control at the front / rear infrared window of the fuselage, and press the ” “power key to start the device.

2. Focus/Keystone
   Adjust the focus wheel of the body Adjust the keystone correction until the picture Is clear (please wheel of the fuselage until the keep the picture above 45 Inches, the screen is square. others will not be clear).
   

3. **Brightness of light source/Zoom

** • Select Brightness of light sou to adjust the brightness of the image.
• SelectZoomto zoom theimage size.
NOTE: Brightness of light source adjustment Is an optional function.

4. Factory Default
   If you encounter problems in the process of use, please plug in the power adapter, you can select – Set – restore factory, in order to return to the initial state of the system.

lnpυF Source

1. USB Connection
   After inserting the USB flash disk, select Movie, Music, Photo, or text according to the desired content to enter the USB flash disk.

2. MD Connection
   Connecting projector and computer, game console, or other devices with HD cable.
   

3. AV Connection
   Connect the DVD, DTV Tuner, etc with AV cable, choose the ‘AV” source input. For DVD Player, DTV Tuner, etc.
   

Projection Distance 8 Size
Note: The display sizes are for your reference. There are more projection sizes for your optional which depends on your need.

Supported multimedia formats

File Audio
play| Format| Suffix

mp3

| Decoding
---|---|---|---
Mp3
M4A| mp4|
Picture play| JPEG| j1:41|
BMP| .bmp|
PNG| .P 1 113|

| MPEG1| DAT\ MPG\ .MPEG| \
MPEG2| .MPG| \
MPEG4| AVI \ MP4| DIV)LXVID
RM\RMVB

._

| .RM\ .RMVB| RV & RV9, RVIO
H264| .MKV \ .MOV| 11264
MJPEG| .AVI| \
DNX| .DIVAAVI| MPEGDIVX.H264
FLV| .RV| H264

NOTE: Support up to 101IP tarantula..

TroubleShootina

Q: Why is the projection screen so blurry?
A: Please keep the projection screen above 45 inches and adjust the focus until the screen is clear.
0: Connected to my laptop via HDMI port, but projector keeps ‘No signal’?
A: Please make sure your laptop is set to projection model( still fails, please try to connect the projector to other devices such as TV stick with the HDMI cable. lf the connection is successful, the projector has no problem. Please check the projection settings Of your laptop.
Q: Why is there no sound when playing Netflix videos?
A: Turn off Dolby surround sound on your connected devices such as Firestick and Chromecast when watching Netflix videos.
Q: Why does the projector screen flicker?
Ai If you unplug the power directly during use, the screen will flash slightly when you start it next time and disappear after 5 minutes. Please do not unplug the power during use. If you need to shut down, please press the remote control to shut down

*100140mm**

Documents / Resources

| Sichuan Coolux Technology V501 LED Projector [pdf] User Manual
V501, 2AXBD-V501, 2AXBDV501, V501, LED Projector, Projector
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>