GROUND ZERO GZIW 200 Iridium Series Subwoofer Owner’s Manual
- June 10, 2024
- Ground-Zero
Table of Contents
GROUND ZERO GZIW 200 Iridium Series Subwoofer
Product Information
- The IRIDIUM series is the entry-level product line from GROUND ZERO.
- The series includes affordable amplifiers, speakers, and subwoofers designed for daily use and SPL (Sound Pressure Level) purposes.
- The GZIW 200 is a subwoofer driver that offers amazing performance and useful features.
- The subwoofer is equipped with a 38 mm voice coil and has a nominal impedance of 4 ohms.
- The frequency response of the subwoofer ranges from 32 Hz to 150 Hz.
- The subwoofer has a sensitivity of 87 dB and can handle up to 150 watts of power.
- The recommended enclosure volume for the subwoofer is 17 liters net for bandpass (4th order), 14 liters net sealed, and 18 liters net vented. However, the perfect tuning (especially port length) may vary based on your car and personal taste.
Product Usage Instructions
- Ensure safety by reading the safety instructions provided in the manual before installing or using the product.
- Refer to the general installation note provided in the manual for guidance on installing the subwoofer.
- Use the recommended enclosure volumes for bandpass (4th order), sealed, or vented enclosures depending on your preference and car specifications.
- Adjust the tuning of the enclosure to achieve the perfect sound quality based on your personal preference and car specifications.
- Respect the music by using the product responsibly and within the recommended specifications to avoid damage or injury.
For more information or technical support, please contact GROUND ZERO GmbH at the address and contact details provided in the manual or visit their website.
Features
- High-quality 8” subwoofer
- Klippel® optimized
- 1.5” copper voice coil
- Durable rubber surround
- HQPP cone with 3D structure
- Polycot spider
- Resonance-free steel basket
- Push terminal
Introduction
Thank you for choosing a great GROUND ZERO product! We hope you will enjoy
this product from the IRIDIUM series.
This owner´s manual contains the information you need to use this product.
Please read it carefully in order to achieve the best possible result. Your
car audio specialist or our customer support will answer further questions
about the product and its use.
Subwoofers are an important part of your car audio system. Please keep in
mind, however, that they can only achieve their full performance if all other
components of the entire system are carefully coordinated with one another. It
is therefore recommended to consult a car audio specialist dealer or workshop
for the assembly of the system and its installation and sound adjustments.
Series – Top Performance
Representing the entry level of GROUND ZERO, the IRIDIUM series offers many useful features and amazing performance. The line-up contains a variety of affordable amplifiers, speakers and subwoofers for daily use and even for SPL purposes. Apart from subwoofer drivers, there are loaded passive and active enclosures available in different sizes for many applications and demands
General installation note
- Never drill a hole to the vehicle´s gas tank or brake lines, to wirings or any other important vehicle parts!
- Never pass wires over sharp edges or vehicle parts to avoid any kind of damage
- Keep the wiring away from the antenna and electronic devices contributing to radio reception
- Lay the power supply wiring always separated from speaker wiring to avoid disturbance
- Use adequately dimensioned power and speaker wires to connect the component
Safety instructions
- Safety instructions : Keep all parts of the content and the packaging away from children and pets to avoid accidents and the risk of suffocation. Permanently extreme levels of over 85 dB can lead to irreparable damage to the hearing. Music systems with high amplifier output power can reach levels of 130 dB or more. Extreme levels can also hinder the perception of important traffic noises and distract from what is happening on the road. Ground Zero GmbH and its sales partners expressly assume no responsibility for hearing damage, physical damage or any damage to property or consequential damage resulting from improper or careless use or improper installation of its products. In particular, any claims are forfeited through the use under competitive conditions.
- Manufacturer’s declaration : Hereby, Ground Zero GmbH declares that this product conforms to the rules of the following EU directives (including all applicable changes): 2011/65 / EU RoHS2 and 2001/95 / EC directive on general product safety. The full text of the EU Declaration of conformity is available at
www.ground-zero-audio.com. Loudspeakers contain magnetized metals and some valuable raw materials and must not be disposed of with normal household waste. Please leave defective or no longer required
Terms of warranty
The limited warranty for this product is covered by GROUND ZERO´s regional distribution partners and their terms and conditions. For further information contact your local retailer or distributor
Specifications
Modell / model | GZIW 200 |
---|---|
Schwingspule Ø / voice coil Ø | 38 mm / 1.5″ |
Impedanz / impedance | 4 Ohm/ohms |
Re | 3.7 Ohm/ohms |
Fs | 32 Hz |
Qms | 6.53 |
Qes | 0.47 |
Qts | 0.44 |
Vas | 23.6 L / 0.83 cu.ft. |
Le | 1.50 mH |
Mms | 62.6 gr |
BL | 10.11 |
Xmax | 20 mm / 0.79″ |
Wirkungsgrad / e fficiency (SPL 1w/1m) | 87 dB |
Belastbarkeit (RMS) / Power handling (RMS) | 150 Watt / Watts |
Empfohlene Verstärkerleistung /
Recommended amplifier power
| 100 – 200 Watt / Watts
Power handling
Recommended enclosures
Bandpass ( 4th order)| 14 Liter netto geschlossen / 0.49 cu.ft. net sealed 18
Liter netto ventiliert / 0.64 cu.ft. net vented
---|---
Port| 1 x 7 cm / 1 x 2.76”
Portlänge / port length*| 28 cm / 11.0”
Abstimmfrequenz Fb / tuning frequency Fb| 60 Hz
Bandbreite / b andwidth (-3dB)| 40 – 91 Hz
The above-mentioned enclosure recommendations are just a few possible
variations.
Please note that you should find the perfect tuning, especially port length,
based on your car and own taste
Wiring options
Verified with KLIPPEL®
GROUND ZERO is using the worldwide accepted KLIPPEL® R&D Analyzer KA3
measurement system for speaker development during the German in-house
development as well as for QC reporting for most production lines at the
factory. The results of LPM and LSI measurements are the basis for evaluating
and verifying further development enabling to offer of perfectly working
products in any practical application. Continuous and advanced training for
development employees ensure the highest possible qualification.
The Linear Parameter Measurement (LPM) module of the KLIPPEL® Analyzer System
is dedicated to identifying the electrical and mechanical small signal
(Thiele/Small) parameters of electro-dynamical transducers with high accuracy.
It is based on the electrical impedance by measuring the voltage and current
at the speaker terminals. An additional benefit of the displacement
measurement is the identification of the suspension creep parameters,
resulting in better accuracy of the loudspeaker model at low frequencies. The
LPM provides tools to identify and avoid typical problems such as poor signal-
to-noise ratio and malfunction due to nonlinear effects of the driver or
amplifier limiting.
The Large Signal Identification (LSI) module measures the linear, nonlinear,
and thermal parameters of transducers operated in free air. The transducer is
operated under normal working conditions (vertical position and fixed clamped
in a laser stand or enclosure). Starting in the small-signal domain, the
amplitude is gradually increased up to limits admissible for the particular
transducer. The maximal amplitude is determined automatically using the
identified transducer parameters and general protection parameters describing
the thermal and mechanical load. The identification of the model parameters is
performed in real-time with an adaptive system. It is based on the estimation
of the back EMF from the voltage U(t) and current signal I(t) measured at the
electrical terminals. The identified model allows for locating the sources of
the nonlinear distortion and their contribution to the radiated sound. The
dynamic generation of a DC-part in the displacement, amplitude compression,
and other nonlinear effects can be investigated in detail. After the initial
identification, a temporal parameter variation and long-term thermal effects
can be investigated KLIPPEL® R&D hardware and dB-Lab software for LPM/LSI
measurements meet the following standards: Consumer Electronics Association
CEA-2031(LSI module)
International Electrotechnical Commission IEC 60268-5, IEC 60268-7, IEC
60268-22, IEC 62458, IEC 62459, IEC WD 63034 European Standards BS EN 54-24
Audio Engineering Society AES2 Institute of Electrical and Electronics
Engineers IEEE 269, IEEE 1206, IEEE 1329, IEEE 1652
KLIPPEL® is a registered trademark of KLIPPEL GmbH
Respect the Music
Listening to music can be emotional, impressive, relaxing or enjoyable. At that, it doesn´t really matter what kind of music is my personal favorite, whether it´s Instrumental, Jazz, Electro, Latin, Classic, Rock or any other music direction. However, audio reproduction quality at each desired volume is elementary. Some music styles require higher levels while others prefer soft tones. GROUND ZERO considers all the different wishes of customers during the development of new products. Along with this, the target is to create the most realistic sound, to transfer the soul of the music and the intention of the performer. Summarized to one phrase: RESPECT THE MUSIC! components to a local recycling facility at the end of their practical use.
GROUND ZERO products are engineered in Germany
GROUND ZERO – international sponsor of Ground Zero GmbH Erlenweg 25 – 85658
Egmating – Germany
Tel. +49 (0)8095 / 873 83 -0 Fax -10 www.ground-zero-
audio.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>