REKUDO RK500-05 Swaybar Endlink Kit Instruction Manual
- June 4, 2024
- REKUDO
Table of Contents
REKUDO RK500-05 Swaybar Endlink Kit
Kit Contents:
| Description | Qty. |
|---|---|
| Tesla Model 3 LHS Rear Endlink | 1 |
| Tesla Model 3 RHS Rear Endlink | 1 |
| M10 x 1.25 Nyloc Flange Head Nuts | 4 |
| M10 x 1.5 x 25mm Flange Head Bolts | 4 |
INSTALLATION
Read All Instructions Before Beginning Installation
- Only qualified mechanics experienced in the installation and removal of suspension components should perform this installation.
- Use of a hoist and screw jack is highly recommended and will substantially reduce installation time.
- Installation time is approximately 1 hour with the use of a hoist.
- Never work on or under a vehicle unless it is properly supported.
Installation Instructions:
- Install (x4) M10 bolts through the swaybar bushing brackets (x2 per side) into the vehicle. Torque to 40 ft./lbs. (Figure 1).
- Install swaybar endlinks onto bar and into rear vehicle spindle, as shown. Install (x4) M10 nuts onto the endlinks. Torque to 40 ft./lbs. (Figure 2).
Technical Service: 1-866-464-6553
Phone: 1-270-781-9741
For online help, please refer to the Tech Service section of our website:
www.holley.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>