BUNN 44050.0200 TF 1.5 Gallon Stainless Steel ThermoFresh Server User Guide
- June 4, 2024
- BUNN
Table of Contents
BUNN 44050.0200 TF 1.5 Gallon Stainless Steel ThermoFresh Server
USE & CARE INSTRUCTIONS
- The server must be placed on a sturdy counter or shelf.
- Place a cup or container in center of serving platform as indicated.
- Open the faucet handle until the desired quantity is dispensed.
DAILY CLEANING
-
STEP 1 Run a complete brew cycle of hot water into the server and let it set for a minute. Empty the server completely by opening the faucet.
-
STEP 2 Flip the lid, fill server with cleaning solution and thoroughly clean the inside of server.
-
STEP 3 Rinse server thoroughly using fresh water rinse.
-
STEP 4 Fully fill server with sanitizing solution for 5 minutes and then drain through fully open faucet.
NOTE: Bunn-O-Matic recommends the three step method for cleaning and sanitizing the server. The 3 step method consists of hot soapy water using an mild, non-citrus detergent, a fresh water rinse and an aqueous sanitizing solution using a non-chlorine sanitizer. Do not submerge the server. Failure to follow the recommended cleaning procedures can cause corrosion to the stainless steel surface and damage the vacuum seal. USE OF ANY CHLORINATED PRODUCT VOIDS THE FACTORY WARRANTY.
Do not submerge server.
-
STEP 5 Remove the faucet handle/stem assembly by unscrew-ing the faucet nut.
-
STEP 6 Use cleaning brush supplied with the server to thoroughly clean the fill tube of the lid assembly and the faucet spout.
-
STEP 7 Wash the entire outside surface of the lid assembly with a mild detergent, water solution, and a soft, non-abrasive cloth and rinse with hot water. Do not submerge.
NOTE: Thoroughly cleaning the lid assembly fin will prevent inaccurate level readings. -
STEP 8 Disassemble the faucet/stem assembly. Thoroughly wash all faucet parts, drip tray and cover in a mild detergent and water solu-tion. Rinse the parts in hot water. Sanitize the parts for five minutes, then air dry completely.
-
STEP 9 Remove the drip tray and drip tray cover. Thoroughly wash in a mild detergent and water solution. Rinse the parts in hot water.
-
STEP 10 Reassemble the faucet and attach it to the dispenser.
CAUTION: When reassembling, DO NOT over-tighten faucet bonnet. Hand tighten only. -
STEP 11 Wash the entire outside surface of the server with a soft, non-abrasive cloth. Do NOT clean with a water jet device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>