SUPERIOR ETK36-B Wood Burning Appliance Kits and Accessories Installation Guide
- June 10, 2024
- Superior
Table of Contents
SUPERIOR ETK36-B Wood Burning Appliance Kits and Accessories
SHIPPING AND PACKING LIST
Edge Trim Kit must include:
- 1 – RH Side Trim
- 1 – LH Side Trim
- 1 – Top Frame Trim
- 1 – Lower Mounting Frame Trim*
- 2 – Upper Mounting Frame Trim*
*Note: Upper and lower mounting frame trim included with Models 42 only
The Edge Trim Kits covered in this document are:
- Catalog # Model #
- 91L57 ETK36-B
- 91L58 ETK36-P
- 91L61 ETK42-B
- 91L62 ETK42-P
FIREPLACE EDGE TRIM KIT INSTALLATION INSTRUCTIONS
-
Step 1. Remove fireplace grille assemblies by lifting up and out of holes on frame. Then pull from bottom out towards you. (Figures 1 and 2 ).
Note: Lift grille near outer support rods to fully clear holes. -
Step 2. There is a right hand and a left hand trim. Install side trims carefully. Place trim on side frame and press firmly to fit around frame (Figure 1 ).
-
Step 3. Install the top frame trim with two screws as shown in Figure 2.
Note: The ends should overlap the side trim pieces a little. Step 4. 42 Models only. Install one of the two upper mounting frame trim pieces by aligning the three holes of the trim to the three holes of the fireplace. Fasten with three screws. -
Step 5. 42 Models only. Install the lower mounting frame trim.
Align the two holes of the trim to the two holes of the fireplace. -
Step 6. 42 Models only. Align the two end holes of the second upper mounting frame with the holes on the lower fireplace frame and secure with two screws.
-
Step 7. Adjust all trim pieces and ensure that all screws have been tightened. Reinstall louvers.
-
Step 8. Remove protective covering from trim pieces and wipe with a damp cloth.
-
Step 9. Reinstall louvers.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>