starlight C206 Remote Controller Panel Instructions
- June 10, 2024
- starlight
Table of Contents
C206 Remote Controller
Panel Instructions
C206 Remote Controller Panel
Attention
- Please read these operating instructions carefully to familiarize you with basic operations of this unit BEFORE USE.
- Without permitted, it is prohibited to spread the contents of this manual to others.
- This manual is only to provide related information, and the contents of this manual will be changed at any time without notice.
- Unless the instructions have alreadystated, please do not freely modified the unit.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can bedetermined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not
expressly approved by the party responsible for compliance. such modifications
could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. This
equipment complies with FCC’s RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna(s) must not be co-
located or conjunction with any other antenna or transmitter.