Shark UZ345H Rocket Powerfins Cordless Vacuum User Manual

June 10, 2024
Shark

Shark UZ345H Rocket Powerfins Cordless Vacuum User Manual

Shark UZ345H Rocket Powerfins Cordless Vacuum

MODEL: UZ345H
QUICK START GUIDE

[Please make sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.]

For questions, visit us online at sharkclean.com/support
Register your vacuum at registeryourshark.com

WHAT’S INSIDE:

A. Handheld Vacuum
B. PowerFins Floor Nozzle
C. Wand w/Handheld Storage Clip
D. Crevice Tool
E. Dusting Brush
F. Charger
G. HEPA Post-Motor Filter (Pre-Installed)

ASSEMBLY

ASSEMBLY

For complete maintenance instructions, see the enclosed Owner’s Guide.
For additional parts and accessories, visit sharkaccessories.com
For additional batteries and charging accessories, visit sharkclean.com/batteries

POWER SETTINGS

OFF:

Slide switch to the top to turn off power. To begin vacuuming in Standard Mode, slide switch to the appropriate setting.

BARE FLOOR SETTING:

Bare Floor/Area Rugs Slide switch to the middle. The brushroll spins slowly to clean bare floors and small area rugs.

CARPET SETTING:

Carpet
Slide switch to the bottom. The brushroll spins faster to pick up debris below the surface of your carpets.

BOOST MODE:

For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.

NOTE : For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the trigger to go into Boost mode.

NOTE : Select Carpet setting for stuck-on dirt and debris.

LI-ION BATTERY

In Use

NOTE : Full charge takes approximately 3 hours.

Battery Indicator Lights

NOTE : The battery comes partially charged. Charge fully before first use.

CHARGING

To charge, remove the handheld vacuum from the wand by pressing the Wand Release button and pulling up. Plug the charger into the charging port.

CHARGING

Battery Runtime

MODE MINUTES
Hand Vac 40
Bare Floor/ Standard Mode 25
Carpet Mode/ Standard Mode 20
Boost Mode (Hand Vac) 10

VERSATILE CLEANING

Slide the power button to the desired power setting. Place your foot on the floor nozzle and tilt the handheld vacuum back.

CLEANING

NOTE : Brushroll will only engage when the handle is tilted back.

To detach the wand for above-floor cleaning, stand the vacuum upright, then press the Nozzle Release button on the bottom of the wand and pull the wand up to disconnect it.

OR

To detach the handheld vacuum, press the Wand Release button and lift the handheld vacuum off the wand.

THEN

Attach a cleaning accessory, then choose the power setting.

EMPTYING THE DUST CUP

1. To empty the dust cup, first disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up on the handheld vacuum.

2. Position the dust cup over a trash bin and slide the CleanTouch™ Dirt Ejector forward.

© 2020 SharkNinja Operating LLC. ROCKET and SHARK are registered trademarks of SharkNinja Operating LLC. CLEANTOUCH is a trademark of SharkNinja Operating LLC.

UZ345H_QSG_MP_Mv4


DOWNLOAD

Shark UZ345H Rocket Powerfins Cordless Vacuum:

Quick Start Guide – [Download PDF]


Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals