HANMOS XRD-099 Wireless Speaker User Manual
- June 9, 2024
- HANMOS
Table of Contents
wireless speaker
USER MANUAL
XRD-099 Wireless Speaker
Important Notes
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit deferent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Changes or medications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Product Contents
Technical Information
| Working Voltage | 3.2-4.2V |
|---|---|
| Charging Power | DC 5V ± 0.25V |
| Version | V5.0 |
| Recharge Method | Type-C USB |
| Battery Capacity | 2000mAh |
| Power | 5W x 2 |
| Working Range | Barrier Free Space: 32 feet, |
Obstacle Space: >16 feet
Material| Plastic
Connecting Your Device
- Turn on wireless speaker by pressing and holding
- Turn your bluetooth device on search mode. Find device titled “MOBE SOUNDWAVE” and select.
- Once a connection with media device has been established, there will be a tone sound.
Wireless Speaker Functions
Power Recharging
Connect the USB cable included to charge your Wireless speaker through a computer USB port or power adapter. Low Power Warning: When voltage is lower than 3.3V, a tone will sound. Leave for at least 3.5 hours for full charge.
