Govee H6076 RGBIC Floor Lamp User Guide
- June 9, 2024
- Govee
Table of Contents
Govee H6076 RGBIC Floor Lamp
WHAT’S IN THE BOX
INSTALLATION INSTRUCTIONS
- Slide the metal slots of the first Pole B onto the base, and tighten them with two screws.
- Insert a connecting piece with the end showing the smaller holes into the pole. Align its holes with the pole and tighten them with two screws.
- Take the second Pole B, align its metal slots with the bigger holes of the connecting piece, and tighten them with two screws. Make sure the two poles are closely aligned and tightened.
- Repeat the process of steps 2 and 3 with the third Pole B. Pole A should be the last one to be attached
- Straighten the silicone strip light. Connect the wires on the silicone strip light to the wires in the lamp base (wires should be connected by color)
- Ensure the exposed wires are inside the lamp base. Attach the silicone strip light by following the image above. Finally, press the strip light from the middle outwards to the two ends.Connect the adapter to the cable of the lamp base and plug the adapter into a power outlet.
Troubleshooting
-
The silicone light strip is too long.
-
Take out the strip from the pole;
-
Follow step 6 to reinstall.
Note : To avoid deforming the silicone light strip, please press from the top and bottom first, and then press the middle.
Caution : Do not cut the strip short, otherwise it will be damaged. -
After installing all the poles, the gap between them is large or they are skewed.
-
Remove the screws and connecting pieces;
-
Follow step 2 to step 4 to reinstall.
Note : The connecting piece has two ends: one with smaller holes and the other with bigger holes. Please tighten the smaller hole into the screw first, and then the bigger hole. Make sure the two poles are closely aligned and tightened.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>