StealthTronic STronic URP GSM K Plus User Manual
- June 9, 2024
- StealthTronic
Table of Contents
StealthTronic STronic URP GSM K Plus
IMPORTANT: STronic URP GSM K+ is a device which is a combination of 2
different modules, Listening module GSM based and then Voice Recording module
with VOX activation only. To access the device’s recordings, you have to
connect it to a PC and physically get the data.
There are 2 microphones, because each unit uses their own microphone when
needed.
PACKAGE CONTENT
- STronic URP GSM K+
- Software for changing date
- Charger
- USB MINI cable
OVERVIEW
- Microphone
- Micro USB
- Recording diode
- SIM Slot
- Microphone 2
- GSM diode
- ON OFF button (only for voice recorder)
QUICK SET-UP GUIDE
IMPORTANT:
- DEVICE CHARGES WITH CABLE ONLY (faster charging is with enclosed adaptor)
- USE APPROPRIATE OPERATING SYSTEM (Windows XP,7,8,8.1, 10 & MacOs)
- SIM has to be without PIN.
- DEVICE IS NOT WATER RESISTANT
Put in SIM without a PIN code, wait for the unit to FLASH and then you are
good to go. The unit CALL BACK FUNCTION is activated by sending 1111 to the
unit. Turning off is by 0000.
You will turn on the switch as shown on the picture with number 7
.
Take off the SIMCARD and TURN OFF the switch so there is no diodes or flashing on the unit visible. The device is then turned off.
Time set-up
Run the application StealthTronic.exe
Select the desired
- YYYY = Year = 2016
- MM = Month = 10
- DD = Day = 02
This date would refer to 2.10.2016 In case your device goes out of battery, you will have to change the date again.
File with date and time configuration will be created. This will create the
filed which will be recorder onto URP with a time stamp.
TIP: If you need to make recording from last year, you can you simply
change the time to whatever date you need.
CHARGING
The unit has to be turned off. That means, that the SWITCH has to slide to the LEFT.
- Plug the charger to the wall
- RED diode will light continuously | CHARGING
- RED diode will flash | FULL BATTERY
Orientationally you estimate the percentage of battery by following:
- 0—30% battery: No falsh or light
- 30—70% battery: One flash
- 70—100% battery: Light Flashing
FILE ACCESS
Make sure that the unit has been turned OFF with a SWITCH to the LEFT. Connect to the PC and get the files which you need. Get the files which you need, but do not erase the application.
TECHNICAL SPECS
- Number of Microphones 2
- Battery Life: 150 Hrs | 13 hours listening
- Standby Time: 250 Days in voice activation
- Charging Time: 4.5 hrs
- Size: 76 x 33 x 14 mm
- Weight: 67 g
- Voice Activation YES
- Battery capacity 2000 mAh
- Listening 100-150 mAh (GSM)
- Recording 7mAh
FAQ
-
Did you se the date and it is not working?
You have to set it again, if he device went completely out of battery. -
You cannot reach the device?
The device is most likely out of battery, make sure that the PIN is off.
USEFUL INFORMATION
If battery is fully discharged, charging will start 3 min after connecting the
device into power supply. We recommend to format battery before you start
using the device. Charge the device at least 10 hours and then let it
discharged. Repeat three times. After device will be fully formatted, charge
it for 8 hours, ideally. After that, please proceed as stated above.
Please note, quality of mobile signal in the place of installation strongly
affects quality of interception When device is not rechargeable, re-insert SIM
card or re-charge the device When call back function doesn´t work properly,
even if activated, re-insert SIM card.
DISCLAIMER
This user manual can be slightly different from specific product. Before
start using the device, check your local legal terms. Neither supplier nor
distributor don´t assume and responsibility for using device in conflict with
local law.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>