SCHWAIGER LWHDS 5530 Sloping Roof TV Bracket Instruction Manual

: June 4, 2024
: Schwaiger

Table of Contents

GENERAL
- INTENDED USE
PACK AGE CONTENTS
Opration In Detail
- Prepartions For Installation
Technical Data
Mounting
Remote Control
TROUBLESHOOTING
Warranty
CUSTOMER SUPPORT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SCHWAIGER LWHDS 5530 Sloping Roof TV Bracket Instruction Manual

GENERAL

Read the user guide and keep it in a safe place

Congratulations and thank you for purchasing this SCHWAIGER Product.
This user manual is an integral part of this product. It contains important information on commissioning and handling. This product uses electricity. Read the instructions carefully to avoid burns, fire and electric shock, to ensure safe and correct use of the system and to preserve the life of the product in general and the built-in electronics in particular. Store this guide safely throughout the product’s entire service life and pass it on to any subsequent users or owners. Check that the supplied package is complete and ensure that none of the parts are defective or damaged.

INTENDED USE

The product is intended for private use only and is not suitable for commercial use.
Only use the product as described in this user manual. Any other use is considered improper and may result in property damage.
The product is used for mounting suitable TV equipment to straight or sloping ceilings. Its adjustment is motorised and can be controlled via the remote control provided. Only the mains adapter supplied may be used as a power supply for the motorised adjustment. The mains adapter is approved only for connection to an AC voltage of 100-240 V/60/50 Hz.
The mounted TV screen must not exceed the specified maximum values for dimensions and weight. Use is only allowed in closed rooms, not outdoors. Contact with moisture, e.g. in a bathroom, must be absolutely avoide

PACK AGE CONTENTS

TV ceiling bracket (motorised)

A ( x 1 )
**VESA plate

** B ( x 1 )

**Drill template

** C ( x 1 )

Cover (right/left)

D ( x 2 )
**VESA adapter (left)

** E ( x 2 )

**VESA adapter (right)

F ( x 2 )
**

Mains adapter

G ( x 1 )
**Remote control

** H ( x 1 )

**Cable tie

** I ( x 4 )

**Screw M5x14

** M – A ( x 4 )

Screw M6x14

M-B (x4)
Screw M6x30**** M – C ( x 4 )
**Screw M8x30

** M – D ( x 4 )

Screw M8x50**** M – E ( x 4 )
Washer D5**** M – F ( x 4 )
Washer D8**** M – G ( x 4 )
Small spacer Ø15xØ8×5**** M – H ( x 8 )
Screw ST6.3×55**** W – B ( x 6 )
Plug for concrete SX Ø10×50**** W – B ( x 6 )
Washer D6** W – C ( x 4 )
**

General safety and warning instructions

IMPORTANT
Risk of damage!

Improper handling of the product may result in damage to the product..

Do not leave the cables and connectors lying around loose in order to prevent a tripping hazard.
Any attempt to make changes to the product is prohibited.
Do not start the installation until you have read and understood all instructions and warnings in this installation sheet.
If you have any questions about the instructions or warnings, please contact your local dealer.
This bracket should ONLY be installed and used as described in this manual. Improper installation of this product may result in damage or serious injury.
This product should only be installed by a person with good mechanical skills who has basic experience in the field of construction and fully understands this manual.
Make sure that the substrate can safely support the total weight of the unit and all attached parts and components.
Always have another person assist you or use a mechanical lifting device to safely lift and position the unit.
Tighten the screws, but not too tight. Overtightening may cause damage and reduce significantly the load-bearing
capacity of the screws.
This product is intended for indoor use only. Use of this product outdoors may lead to product defects and personal injury.
Do not disassemble or modify the electronic components of the product without permission.

WARNING!
Risk of electric shock!

Faulty electrical installation or excessive mains voltage can lead to electric shock.

The device may only be used with the supplied mains adapter. Modifications to the supplied mains adapter are not
permitted.
Never use the system if the power cord or plug is damaged. If any part is damaged, please contact your dealer for a
replacement part.
Never use the system in a humid environment or when its electrical parts have been in contact with liquids.
Do not clean the unit when it is still connected to the mains.
Do not disassemble or replace any parts while the unit is still connected to the mains.
Unplug the unit from the mains when not in use and keep it out of the reach of children.

WARNING!
Hazards for child renand person swith reduced physical, sensory or mental abilities (for example, partially
disabled persons, elderly person with reduced physical and mental abilities) or lack of experience and
knowledge (for example, older children)

This product can be used by children aged from eight years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved. Children must not play with the product. Cleaning and user maintenance must not be carried out by children without supervision.
Keep children younger than eight years away from the product and the connecting cable.
Do not leave the product unattended during operation.
Do not allow children to play with the packaging film. Children can get caught in it while playing and suffocate.

WARNING

Hazard due to batteries!
If you use batteries improperly , there is a risk of explosion or burns from leaking bettery fluid.

Keep batteries out of the reach of children. Children could put batteries in their mouths and swallow them. If a battery is swallowed, seek medical attention immediately.
Do not dispose of batteries in fire. Do not expose batteries to high temperatures.
Danger of explosion! Do not charge batteries.
Do not open or short-circuit batteries.
Battery acid leaking from a battery may cause skin irritation. In case of skin contact, rinse with plenty of water. If the liquid has got into the eyes, rinse thoroughly with water, do not rub, and consult a doctor immediately

Opration In Detail

Checking Product And supplied Package

IMPORTANT:

Risk Of Damage
The product can become quickly damaged if you do not take care when opening the packaging with a sharp knife or
other sharp objects

Open the packaging very carefully

Remove the product from the packaging.
Check that the supply package is complete.
Check that the product or individual parts are not damaged. If anything is damaged, do not use the product. Contact the hotline or e-mail address given in this operating manual.

Prepartions For Installation

CAUTION!
Before Installing The Product,make sure that there is a working 230 V AC outlet near the product.

The product should be mounted to a supporting ceiling structure. Observe the type of ceiling when mounting. Installation is only permitted if the type of ceiling is suitable for this purpose. Thin lightweight materials or plasterboard, even on sloping ceilings, are usually unsuitable. Specialised shops, however, may have special screw plugs for such mounting locations. If in doubt, have the mounting carried out by a specialist. Depending on the surface (e.g. wood), suitable fastening materials should be used (only screws without plugs, etc.).
Due to the overall weight of the mounted product and the leverage effect, care must be taken to ensure a stable installation. Always determine the load- bearing capacity of the underlying structure. This structure must be able to support at least 10 times the maximum weight of the ceiling bracket and the installed screen to ensure adequate safety

Plan the installation location carefully so that the TV bracket with the screen attached to it is later at the desired height and position.
Use a spirit level for mounting.

Technical Data

TV Celling Mount

Article number| LWHDS5530 513
Mounting dimensions according to VESA standard in mm| 100×100 200×200 300×300 400×200 400×400
Usable screen diagonal| 23˝ – 55˝ (140 cm max.)
Load capacity| up to max. 30 kg
Cable length Power supply unit| 1,2 m
Specification in accordance with regulation (EU) 2019/1782
Power Supply
Manufacturer’s name or trade mark, commercial registra- tion number and importer, address| Schwaiger GmbH, HRB12220

Würzburger Straße 17, 90579 Langenzenn

Manufacturer, address| NINGHAI YINGJIAO ELECTRICAL.,LTD.

Cuijia, Xidian Town, Ninghai, zhejiang 315613, China

Mounting

WARNING

It is the installers’ responsibility to provide fixings for other types of mounting.
The installer must ensure that the surface can support the total weight of the device and all parts and components attached to it.
The installer must ensure that screws and plugs suitable for the surface are used.

WOOD

Remove the lower screws from the VESA plate and save them for later use.
Mounting Instruction

CAUTION

Do NOT overtighten the screws.
Mounting Instruction

WARNING
The movement area of the bracket should not be blocked by objects

Use the cable ties to secure the cables.
NOTE: Allow clearance at the cables for arm movement

WARNING
Do not open the cover of the electrical compartment.
Mounting Instruction
WARNING!
Never use the device without an installed TV

Remote Control

A.Button Function

Up/Down movement
When the button is pressed, the TV bracket moves up to the position closest to the ceiling.
Upon pressing the button, the TV bracket will move down to the position with the maximum tilt angle
(default 75°).
Press the button to stop the movement. (Remove all obstacles from the movement area).
Memory Setting
Press and hold the or button for 1 second and you will hear a beep indicating that the current position has been stored in memory. The or buttons can always be used to store another position
Memory Cell
Press the or button and the TV bracket will automatically move to the position stored under the or button.
Reset
If the TV bracket cannot be set to the highest position (0 degrees to ceiling) or lowest position (maximum tilt), unplug the power cord and plug it back in. Then press and hold the button for 5 seconds. The TV bracket will return to the highest position, i.e. the system has reset successfully
Setting The Tilt Range For Sloping ceilinge
The TV bracket can be adjusted from 0° to 75° as standard. Please set the tilt range when using the TV bracket on a sloping ceiling.
Preparing: Reset the system (see the instructions under A. Button functions – 4. Reset).
Step 1: Press the , and buttons and set the correct position.
Step 2: Press and hold the button until the unit beeps once.
Repeat this step 5 times. The unit will emit a long beep to indicate successful setting.
Note: Steps 1 and 2 must be completed within 2 minutes or the unit will not be set.
Note: The remote control requires two AAA batteries (not included).

B.Manual Mode
If you manually raise the TV ceiling bracket to any position (except the minimum position against the ceiling), it will
automatically return to the minimum position against the ceiling.

C. Coding of the control unit and remote controls

Step 1: With the bracket switched on, press the small button on the control unit with a thin tool as shown. The device ill beep to indicate that the control unit is ready for encoding.
Step 2: Press the button on the remote control and the control unit will beep repeatedly for about 10 seconds, indicating that the remote control is being programmed. The process will be completed automatically until no beep is heard.
Note: The TV bracket can be paired with up to 20 remote controls. To delete all remote controls, press and hold the code setting button for 5 seconds and then release it. The device will beep twice to confirm successful deletion, otherwise deletion is not done.

TROUBLESHOOTING

This troubleshooting guide is intended to help you identify and solve minor problems caused by the unusual operation of our electric TV br

Fault Indeiction

The buzzer will continuously sound and alarm: Position signal error
Reset the system by following the instructions.

Problem With The Remote controller

Abnormal loss of battery powre.
(New batteries run out after 24 hours without the remote controller being used). Please contact us.
The Buttons on the remote control do not work: Check the Batteries
The Remote Control Is weak (Operating range is less than 3 m): Replace the batteries.

Abnormal opration:The Tv Bracket Cannot Be Adjust to 0″ or 75″.
Reset the system by following the instructions.

Product Does Not Work
Check if the mains adapter is properly connected to the product. If it is, please turn on the unit. If you do not hear a
buzzer tone or see a red power indicator, check if the mains adapter is working properly. If the mains adapter does not
work, please contact us. Contact us if the mains adapter works properly but the TV bracket does not.

Disposal

Do not dispose of batteries or electric and electronic devices in the normal household waste. The consumer is legally obliged to return electrical and electronic devices and batteries that are at the end of their useful life to the point of sale or public collection points that have been set up for this purpose. Legislation in the country of use governs individual details regarding disposal. The symbol on the product, the user guide or the packaging indicates this legal requirement

Disclamer
Schwaiger GmbH does not accept any liability or warranty for damages that are sustained due to improper installation or mounting, improper use of the product or non-compliance with the safety instructions.

Manufacturer‘s information
Dear Customer,
Please contact our Technical Support if you need technical advice and your retailer is unable to help you.

Warranty

The warranty period starts when the product is purchased. The purchase receipt, such as a till receipt, invoice or delivery slip, serves as proof of this date. Keep these documents in a safe place. Our warranty is based on our warranty conditions valid at the time of purchase.

Offline Hourse (Technical support in Germen)
Monday to Friday: 8:00 a.m. – 5:00 p.m.