OLIGHT Javelot pro 2 Upgraded 2500 Lumens Tactical Flashlight User Manual

June 9, 2024
OLIGHT

OLIGHT Javelot pro 2 Upgraded 2500 Lumens Tactical Flashlight User Manual

Thank you for purchasing this Olight product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

  • **Javelot Pro 2

**

  • Holster

  • USB Magnetic Charging Cable

SPECIFICATIONS

TURBO

HIGH

MEDIUM

**LOW

**

ll performance measurements in accordance with ANSI/NEMA FL1-2009 standards. Stated data were been measured indoor under 25 degrees celsius, windless laboratory conditions. The data may vary due to environmental and heat dissipation conditions.

Note: The maximum output brightness will decrease as the battery voltage decreases.

USB MAGNETIC CHARGING CABLE — MCC3

Parameter Speci­cation
Charging cable USB type A – magnetic charging connector, length: 0.5m
Input USB A – Type DC 5V 2A
Charging pattern CC&CV
Maximum charging current 2A
Voltage of fully charged battery 4.2V±0.05V
Time to fully charge 9.5 hours (For reference only. When the USB power source

is insufficient to provide 5V 2A power capacity, the charging time will be longer)
Charge indication| Red: charging
Green: full (over 95%) or disconnected with flashlight

PRODUCT OVERVIEW

BEFORE FIRST USE

Please remove the protective film on the lens, and please also unscrew the body to remove the insulating film within the battery compartment, then screw the body back on tightly

INDICATORS ON BOTH SIDES

NOTE: While turning on, if the battery power is less than 10%, the lowest indicator on the right side will glow red.

CHARGING

  • Before the first use please fully charge the product.
  • Connect the USB end of the magnetic charging cable to an external USB  power source, then attach the other end of the cable to the charging port ofthe light (best charging efficiency with a USB power source of no less than 10W (5V 2A). The red indicator means charging, while the green indicator means charging completed (battery level>95%).
  • Only charge with standard MCC3. NOT compatible with other MCC.

DANGER

  • DO NOT shine the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
  • DO NOT cover the light head when the light is on, or place the light head on the ground. The radiation energy of the light may cause damage to the light itself, or even result in burning to flammable objects.
  • DO NOT store the flashlight when its surface is under high temperature.
  • When the flashlight is working on the turbo mode, the surface temperature can reach 55°C. At that time, DO NOT touch the hot surface of the head.

WARNING

  • Keep out of reach of children.
  • DO NOT use the turbo mode continuously when the environmental temperature is high in case the flashlight body is too hot to hold.
  • DO NOT short-circuit the tail switch cap with the ring surrounding it in any manner, including placing it in your mouth or licking it with your tongue.

NOTICE

  • DO NOT short-circuit the tail switch cap with the surrounding ring. A short circuit in this case will result in a weak electric discharge between them and may lead to a complete battery drain if it is in this state for too long.
  • While the flashlight works in the highest brightness level (5 minutes at room temperature) to reach the default temperature limit, the output would gradually reduce to no less than 1,000 lumens to prevent overheating unless the battery is low.
  • The output would be capped when the ambient temperature is below 0°C/32.00 °F. Please preheat the flashlight to restore it to fully functional.
  • The magnetic tail is easy to attract iron debris. Please keep the tail switch cap and the ring surrounding it clean.

Hazard Hot surface
Human behaviour that is intended to be caused after understanding the safety sign’s meaning. Taking care to avoid coming into contact with a hot surface.

EXCLUSION CLAUSE

Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual .

HOW TO OPERATE

TAIL SWITCH

Constant Low Mode : Quickly half-press the tail switch to produce a low light output or turn the light off (if already on).

Momentary Low Mode : Half-press and hold the tail switch to enter momentary on mode and release the tail switch to exit the mode.

Constant Turbo Mode : Quickly full-press the tail switch to enter turbo or turn the light off (if already on). To exit turbo mode, full-press the tail switch again.

Momentary Turbo Mode : Full-press and hold down the switch to enter momentary turbo on mode. Release the switch to exit turbo mode.

SIDE SWITCH

Press and hold the side switch to turn the flashlight on or off. It memorizes the last mode you selected via the side switch.

When turning on, single click the side switch to cycle through the modes. Starting from the present one, the brightness level will switch to the next one from low to high. When in turbo mode, single click the side switch to access the low mode

WARRANTY

Within 30 days of purchase : Contact the original seller for repair or replacement.

Within 5 years of purchase : Contact Olight for repair or replacement.

Battery Pack : 2 years.

USB Magnetic Charging Cable : 1 year.

This warranty does not cover normal wear and tear, modifications, misuse, disintegrations, negligence, accidents, improper maintenance, or repair by anyone other than an authorized retailer or Olight itself.

EU-Declaration of Conformity


EU-Declaration of Conformity can be found here: https://olightworld.com/ec- declaratio

Dongguan Olight E-Commerce Technology Co., Ltd

4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan Town, Dongguan City, Guangdong, China.
Made in China

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals