SIBRILLE Stepless Dimmable LED Floor Lamp User Manual
- June 9, 2024
- SIBRILLE
Table of Contents
SIBRILLE Stepless Dimmable LED Floor Lamp User Manual
INSTRUCTIONS
Attention: Tile remote control needs to be paired before us
How to pair the remote control with the light
- The remote control should be equipped with batteries.
- Keep long press the on-off key (the first button on the left side of the remote control) of the remote control for more than 5 seconds. And plug the power into the socket when pressing.
- If the light flickers, it indicates that the pairing is successful. The remote control can now be used.
SPECIFICATION
| Name | LED floor lamp |
|---|---|
| Material | Metal + Plastic |
| Color | Matt Black |
| Wattage | 20W |
| Luminous Flux | 1300LM |
| Brightness Adjustment | Stepless dimmable(5%-100%) |
| Color Temperature | 3000k-6000k |
| Lifespan | 40,000Hrs |
| Adapter Voltage | DC24V 1A |
| Input Voltage | AC100-240V 50/60Hz |
| Protection class | IP20 |
REMOTE CONTROL
The Remote distance is within 25ft (7.62 m). It is magnetic so that you can stick it on the lamp pipe and other magnetic surfaces.
| One hour timer ( Light get several flicker mean lh timer is Successful set).
---|---
| Short press to turn on/off light.
| Short/Long press to enhance the CCT (3000K to 6000K) as you like. Short/Long
press to lower the CCT (6000K to 3000K) as you like.
| Short/Long press to enhance the brightness as you like. Short/Long press to
lower the brightness as you like.Short press to be the max brightness and CCT
immediately.
| Short press to enter leisure mode,
| Short press to enter reading mode.
| Short press to enter breastfeed mode.
| Short press to enter night light mode.
| Short press to enter work mode.
NOTICE
- Read the instructions before using the lamp.
- To ensure long lifetime keep the lamp away from damp, hot or corrosive environments.
- Check for transport damage after receiving the packaged lamp.
- Do not disassemble or repair the lamp if you are not qualified to do so by your local regulations.
- Use it with appropriate voltage.
- Do not use frayed appliances or damaged cables.
- Do not touch electrical appliances with wet hands and keep it away from fluids.
- Only use the included power adapter.
- Please cut of the power when the device is not used.
- 0nly clean with dry cloth, no solvents or cleaning solutions.
- Do not use if exceed the voltage.
WARRANTY
Offer 12-Month Warranty of this floor lamp, any question about the use of product ,contact the email: [email protected]
The solution when the remote control cannot control the floor lamp normally:
MATCH CODE
Code matching operation method: Power off the product, and then make sure that
the indicator light of the remote control can light up normally. Continue to
press and hold the power button of the remote control, and then power on the
product (Note that the remote control is still in the state of long-pressing
the switch at this time) until the power supply of the product flashes
feedback, indicating that the matching is successful, and it can be used
normally.
CLEAR CODE
Clear code operation method: powered off/on the DC quick connector of the
product 5 times in rapid succession, and the light source of the product will
flash quickly for 5 times, indicating that the clearing is successful. At this
time, all the remote controls that have been stored on the product have been
cleared. If you want to use the remote control to control this product
normally again, please refer to the above method of matching and connecting
the remote control, and then connect the matching remote control again, you
can use it normally.
If you have any questions, please contact us via amazon.
[email protected]