hp M112e Series LaserJet Printer User Guide

: June 4, 2024
: HP

Table of Contents

Control panel
Light patterns
Printer features
Help and tips for Wi-Fi and connectivity
Exclusive HP+ Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

hp M112e Series LaserJet Printer User Guide

Control panel

Wireless button and light
Resume/Cancel button
Attention light
Power button

Light patterns

Ready
Processing
Initializing, cleaning, or cooling down
Error, manual feed, manual duplex, cartridge very low, or out of paper If blinking fast, press to continue printing or to print the information page.

For a complete list of light patterns, refer to user guide on: hp.com/support.

Printer features

Output bin
Cartridge access door
Front door and input tray
USB port
Power connection

Do not use USB for setup

Printers with a label covering the USB port must be set up with HP Smart and an Internet connection. After setup, you can print using a USB cable if needed, but the printer must also remain connected to the Internet. Remove the label to uncover the USB port when needed.

Help and tips for Wi-Fi and connectivity

If the software is unable to find your printer during setup, check the following conditions to resolve the issue.

Potential Issue

|

Solution

---|---
Printer Wi-Fi setup mode timed out
Potential Issue | If the Wireless light is not blinking blue, the printer might not be in Wi-Fi setup mode. Restart setup mode:

Press and hold on the control panel until light starts blinking, and then release the button.
Wait for the printer to restart.
Open the HP Smart app and add the printer. If needed, swipe right/left on the top of the home screen to find the Add Printer option.
Note: Only 2.4 GHz connection supported.

Computer or mobile device too far from printer| Move your computer or mobile device closer to the printer. Your device might be out of range of the printer’s Wi-Fi signal.
Computer connected to a Virtual Private Network (VPN) or remote work network| Disconnect from a VPN before installing HP Smart software. You can’t install apps from the Microsoft Store when connected to a VPN. Connect to the VPN again after finishing printer setup.
Note: Consider your location and the security of the Wi-Fi network before disconnecting from a VPN.
Wi-Fi turned off on computer (computer connected by Ethernet)| If your computer is connected by Ethernet, turn on the computer’s Wi-Fi while setting up the printer. You don’t need to disconnect the Ethernet cable.
Bluetooth and location services are turned off on your mobile device| If setting up with a mobile device, turn on Bluetooth and location services. This helps the software find your network and printer. Note: Your location is not being determined and no location information is being sent to HP as part of the setup process.