MONOGRAM ZK1SN189NLH Stainless Steel Door Panel Kit Instruction Manual
- June 9, 2024
- MONOGRAM
Table of Contents
Stainless Steel
Door Panel Kit
Installation Instructions
ZK1SN189NLH Stainless Steel Door Panel Kit
Before you begin – Read these instructions completely and carefully.
Note to Installer: Be sure to leave these instructions with the Consumer.
Note to Consumer: Keep these instructions with your Installation
Instructions for future reference.
WARNING: Tip Over Hazard. These appliances are top heavy, especially with
any doors open, and must be secured to prevent tipping forward which could
result in death or serious injury. Read and follow the entire installation
instructions for securing the appliance with the anti-tip system before
installing door panel kit.
WARNING: Door Trim Pinch Point Hazard Improper installation can lead to a
finger pinch point hazard between the side door trim and the cabinets when
operating the door, especially with children. To minimize this risk you must
follow the installation instructions for cabinet dimensions, trim assembly,
and door stop angle.
This kit provides for the installation of the Stainless Steel Door Panel
Assemblies and Stainless Steel Toe Kicks
ZK1SN189NLH | LH 18″ STAINLESS STEEL DOOR PANEL |
---|---|
ZK1SN184NRH | RH 18″ STAINLESS STEEL DOOR PANEL |
ZK1SN249NLH | LH 24″ STAINLESS STEEL DOOR PANEL |
ZK1SN244NRH | RH 24″ STAINLESS STEEL DOOR PANEL |
ZK1SN309NLH | LH 30″ STAINLESS STEEL DOOR PANEL |
ZK1SN304NRH | RH 30″ STAINLESS STEEL DOOR PANEL |
ZK1SN369RLH | LH 36″ STAINLESS STEEL DOOR PANEL |
ZK1SN364RRH | RH 36″ STAINLESS STEEL DOOR PANEL |
ZKSP1H1CNSS | MINIMALIST HANDLE FOR STAINLESS STEEL PANELS ONLY |
ZKSP1H1PNSS | STATEMENT HANDLE FOR STAINLESS STEEL PANELS ONLY |
Tools and Materials Required:
T10, T20 and T30 Torx driver / bits
Components Included | Quantity |
---|---|
Stainless Steel Wrap | 1 |
Stainless Steel Toe Kick | 1 |
INSTALL STAINLESS PANEL
-
Remove bottom hinge cover and retain the 4 T30 Torx screws for later installation.
-
Open door to 90°. Slide the panel onto the door with the panel brackets interlocking on top and bottom with the door brackets (make sure not to slide the panel into the cabinetry surround). Center the panel on the door, then slowly close the door while watching to make sure the panel does not contact the surrounding cabinetry.
-
With the door fully closed, carefully slide the panel towards the cabinetry with the goal gap of 1/8”.
FOLLOW THE REMAINDER OF THE STAINLESS DOOR PANEL INSTALLATION INSTRUCTIONS IN THE UNIT INSTALLATION INSTRUCTIONS TO ADJUST AND SECURE THE DOOR PANEL.
INSTALL TOE KICK
- Insert Toe Kick into the slot in the Front Access Cover by rotating it toward you.
- Push the bottom portion of the Toe Kick towards the product and slide into place.
Instructions for this kit
are also included in the full installation instructions included with the
unit.
For the full owner’s manual, visit our website at
monogram.com.
31-1000699 Rev. 0
01-23 GEA
Printed in the United States
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>