Kingston KVR24N17S8/8 8GB 1Rx8 1G x 64-Bit PC4-2400 CL17 288-Pin DIMM Memory Module User Guide
- June 9, 2024
- Kingston
Table of Contents
KVR24N17S8/8 8GB 1Rx8 1G x 64-Bit PC4-2400 CL17 288-Pin DIMM
Memory Module
User Guide
KVR24N17S8/8
8GB 1Rx8 1G x 64-Bit PC4-2400
CL17 288-Pin DIMM
DESCRIPTION
This document describes ValueRAM’s KVR24N17S8/8 is a 1G x 64-bit (8GB) DDR4-2400 CL17 SDRAM (Synchronous DRAM), 1Rx8, memory module, based on eight 1G x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR4-2400 timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:
FEATURES
- Power Supply: VDD=1.2V Typical
- VDDQ = 1.2V Typical
- VPP – 2.5V Typical
- VDDSPD=2.2V to 3.6V
- Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals
- Low-power auto self refresh (LPASR)
- Data bus inversion (DBI) for data bus
- On-die VREFDQ generation and calibration
- Single-rank
- On-board I2 serial presence-detect (SPD) EEPROM
- 16 internal banks; 4 groups of 4 banks each
- Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS)
- Selectable BC4 or BL8 on-the-fly (OTF)
- Fly-by topology
- Terminated control command and address bus
- PCB: Height 1.23” (31.25mm)
- RoHS Compliant and Halogen-Free
SPECIFICATIONS
| CL(IDD) | 17 cycles |
|---|---|
| Row Cycle Time (tRCmin) | 45.75ns(min.) |
Refresh to Active/Refresh
Command Time (tRFCmin)| 350ns(min.)
Row Active Time (tRASmin)| 32ns(min.)
Maximum Operating Power| TBD W*
UL Rating| 94 V – 0
Operating Temperature| 0º C to +85º C
Storage Temperature| -55º C to +100º C
*Power will vary depending on the SDRAM used.
MODULE DIMENSIONS
kingston.com
Document No. VALUERAM1537-001.A00
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>